Other what have u done on ur disco today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
After my daughter said this seat belt feels weird I spent the whole day welding yes, that's right Disco 1 seat belt mount had rusted so much that it just became unattached and banged around in its little void!
Remove the nearside jump seat and all the trim to find lots of rust!!!
Welding nuts to back of patches with spreader plates and hoping they all line up when done!! And how the hell do you paint the outside of the inner quarter panel?? Don't want one now but from what I can tell you can buy every panel possible for a Disco 1 - except that one!! What's that all about??? Oh well - done now - no gleefully mocking allowed!!!

Take the outside off ...

http://www.mig-welding.co.uk/forum/threads/landrover-discovery-derustification.41008/

IMG_0031_640.JPG
 
Is this project still in process? I have a similar one on the go but a lot of it is learning as I go. I also have to replace one of the tube brackets and the fuel tank cradle one

There are many threads on de-rustyfying a Disco ...

Have a search around ...
 
Did you remember to clean the red plug and allow some time for the harness between the cylinder head and the ECU to drain out?
You will probably have to clean the red plug a few times yet before you can be sure that everything is OK.
I took the ECU out and laid it on its side over night and let any oil out! lucky it was not to much also cleaned red plug. will check it again in a couple of days good point thank you didn't think of that. Just trying remove head lining now to repair sun roof leaks both front and rear.
 
Back
Top