I would just like to say

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Pics or it never happened... he tried. ;)
feet.jpeg
 
Mornin
Cloudy bright here but not cold
Had my recently mot'd car inspected by DVSA, done delivery to me miles after mot
One major 'do not drive' fault
Six major mot fail faults
Seven advisories
Off to trading standards now, think the mot garage may be getting points against them.
Stay dry all :)
 
Eye hassa 5.5mm diameter hole in somefink which needs the hole opening up so its centre is moved 3mm along. Last time eye tried to drill anuvva hole inner hole eye nearly lost me finger. Tis 1.6mm steel. Gittid 10 holes to do. New holes is 5.5mm diameter anorl. Wot would be yer preferred method?

Piller drill and 5.5mm bit un clamp metal tight. Take it slow and hope a sharp bit bites frew?

Use a side cutting bit?

Ive got stepped drills for this type of work.

Edit I just re-read it so you need to go sideways, when ive done this by putting the drill in the original hole then start to angle
it down & use the middle of the drill bit to take more metal off then use a round file to finish it off.
 
Last edited:
Back
Top