Whooops, I do it again...

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dangermike said:
Sounds like a reasonable list,
Lots of common issues, what Maf will you get? Bosch or the pieberg straight swap?
Looking forward to engine mod!
Click to expand...

Don't know yet. I got spare MAF , will fit it and see how it work, i got boost solenoid on list to check too.
Pebble have low performance on lower rev range up to 2000 - then is a kick and it accelerate as it should. Starting from MAF, if not help, check solenoid for VVC.

Also need to wash it properly:

2014-09-2011.23.45.jpg


Top of rocker cover is dirty with oil
2014-09-2011.24.02.jpg


2014-09-2011.24.49.jpg


The reason is probably clogged engine breather. Will swap it for cyclone BMW version.

here he got a small fuel leak:
2014-09-2011.25.16.jpg


and some crap on boost pipe:
2014-09-2011.26.11.jpg


There is a lot of mud, dirt everywhere - bleh, half day of washing and cleaning.
 
It have it on side of intake manifold in this MY, MAP on pipe are present in facelift ones :)

Yep air pipe is... VEEEERY DIY :censored:
 
Put my hands into engine... it still works :D

2014-09-2215.32.22.jpg


After intake manifold remove :eek:
IMG_1285.jpg

A little dirty one...

All is cleaned up now, no photo for now as I finish after dusk...
Few things to do:
-Injector washers
-Injector loom
-Spill return pipes
-Thermostat
-New battery as somebody put dying 68 Ah

Starts up fine
IMG 1273 - YouTube

Tailgate need to be replaced, as rust under handle "eat it" badly
 
Hi Winu

read a lot of your threads - a real Freelander guy :):)

what are you going to use to reach 150 HP ?
the engine is good for this power as that's what it gives in a BMW

thanks and good luck
 
When fitted and fished those will have a little less shine... but still bling :D

Should looks about like this:
1798553_658548890874636_87521102_n.jpg


Because I don't give them to galvanisation
 
Gotta admit I hate chrome infact I dispise it even on my old spitfire I used to have totally hated it, if I had a chance in the future I'd Nickel plate over chrome every time ( saw it on american chopper once) looks loads better..
 
This is not a true chrome (in definition), this is a paint job ;) , always can change it. But want to check how it will be look with bling on a-bar, outer part of side steps and on wheels ;D
 
You must log in or register to reply here.

Similar threads

C
Long Start Td4
2
Replies
31
Views
1K
ChrisMidWales
C
OlympicLiftingPaulF
Noisy Drop Link (Again)
Replies
4
Views
458
pwood999
pwood999
N
freelander1 2002 td4
Replies
13
Views
784
J_D
J_D
O
Smoke (steam)
Replies
4
Views
302
Arctic2
Arctic2
B
Freelander TD4 Mk1 Rear Diff - Does anyone have any advice on how to replace the rear diff?
Replies
1
Views
249
Freddie17
Freddie17
Back
Top