blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
that new brown paint job looks good mate roller or sprayed
Sprayed......but changed me mind later and changed it to white
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Sprayed......but changed me mind later and changed it to white
ratty
I'm not special I'm limited edition
- Posts
- 34,277
Myself and the ballast went for a testdrive to see if the new injector seals have solved the cutting out problem. I started with a drive into wells and picked up some coal. After loading up the landy up I then headed out of Wells, past Wookey Hole and Ebbor Gorge and up towards priddy where I stopped for a cup of tea while overlooking the Somerset levels at Deer Leap.
So it is okay now? Or are you awaiting recovery now
Langers
Well-Known Member
- Posts
- 3,162
- Location
- Kent or Shropshire
Drove it to the indoor 4x4 show and spent some cashmonies on a shiny black anodized raptor dash
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
ratty
I'm not special I'm limited edition
- Posts
- 34,277
It seems to be all ok. It took a couple of seconds of cranking over to start it but bearing in mind it hasn't been driven since the fuel pump and seals were changed I'm not too surprised.
I rekon I may need to give the wastegate another jiggle cos I did have a bit of lag at one point and it did overboost a couple of times but apart from that it seems ok.
ratty
I'm not special I'm limited edition
- Posts
- 34,277
Did you push her or did she jump herself?
Neither. she wouldn't get close enough to the edge.
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
This in leu of tomorrow morning, oh and I blew up my tyres as they were all over the place. one had dropped by 5 PSI so I think it might need some sealant on the rim
Put all the bits that I took off yesterday back on Including, Rear seats, subwoofer, 6x9's, chequer plate sills and rear quaters, front grille and surround, driving lights and re-wired Also checked all the levels under the bonnet, topped up with a pint of engine oil, secured the oil breather pipe from block to rocker cover properly with hose clips, stuffed a litre of spare engine oil in a container behind the brake servo to be safe and filled up my spare washer fluid reserve bottle Oh yeah and played with the setting on my amp, so now the bass is coming from the amp-sub and not from tuning the headunit, if I do that the normal speakers don't like that much stick, Got a good amount done today and couldn't have asked for better weather to do it in
Including, Rear seats, subwoofer, 6x9's, chequer plate sills and rear quaters, front grille and surround, driving lights and re-wired Also checked all the levels under the bonnet, topped up with a pint of engine oil, secured the oil breather pipe from block to rocker cover properly with hose clips, stuffed a litre of spare engine oil in a container behind the brake servo to be safe and filled up my spare washer fluid reserve bottle Oh yeah and played with the setting on my amp, so now the bass is coming from the amp-sub and not from tuning the headunit, if I do that the normal speakers don't like that much stick, Got a good amount done today and couldn't have asked for better weather to do it in 
baggyjim
New Member
- Posts
- 2,063
- Location
- gillingham dorset
started to fit my cb got good clean earth new ariel and mount new cb and cant get the swr to drop at all
Drookit Dug
Active Member
- Posts
- 270
- Location
- East Sussex
I took my Defender shooting cos' it's Sunday, then took it to the pub for lunch. Then took my Disco to the jet wash as it's due an MOT this week.
Fatboy11
New Member
- Posts
- 1,074
- Location
- Thatcham, Berkshire.
Cut the bottom of my front shocks off :0
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
started to fit my cb got good clean earth new ariel and mount new cb and cant get the swr to drop at all
sounds like you got a strand of outer braid touching the center core , or the mike lead/plug could be suspect .
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
got the shed finished today and got the 90 back home
then used the petrol pressure washer and got all the crap from the last 3 trips off the underside
and to finish the day got 1 of the rear rubber eyebrow extentions fitted (too dark for picys
then used the petrol pressure washer and got all the crap from the last 3 trips off the underside
and to finish the day got 1 of the rear rubber eyebrow extentions fitted (too dark for picys
discomikey
New Member
- Posts
- 303
- Location
- derbyshire, harper adams
picked it up from the modified vehicles shed at the show. didnt win but i wasnt expecting to as there was some reallllly nice landys there. had a good nosy around mr noisys disco. i want it
andyjd
Member
- Posts
- 79
- Location
- Dunedin, New Zealand
Drove it around Saturday and Sunday... Today took it for it's WOF (aka MOT) and it passed
Ninja Haggis
New Member
- Posts
- 3,781
- Location
- Aberdeenshire
Today, we did do the challenging task of .....
Fitting new tax disc holder wot I had made speshul :
NH Tax Disc Holder (1275 x 844)
Fitting new tax disc holder wot I had made speshul :
NH Tax Disc Holder (1275 x 844)
big si
Well-Known Member
- Posts
- 4,651
- Location
- black country
I bet that was a taxing jobToday, we did do the challenging task of .....
Fitting new tax disc holder wot I had made speshul :
NH Tax Disc Holder (1275 x 844)
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
Ninja Haggis
New Member
- Posts
- 3,781
- Location
- Aberdeenshire
the princely sum of £ 3.25 delivered.
I fort that wasn't too bad
I fort that wasn't too bad
