What have you done to your Landie today.

bluesticky1 · Apr 21, 2011

Jate rings

markconnor33 · Apr 21, 2011

Nothing!!!

Although did take it out for a little run to do my waste veg oil collections and took the kids out in it to get a "slush puppy" for my 7 yr old daughter as a treat for being really good in School easter production.

Mark

big si · Apr 21, 2011

my headlight switch decided to pack up at 10pm when i finished work so spent 15 minutes wiggling the stalk until they came on ,must have looked like i was having a furious tug to any passers by, aside from occasionally flashing side lights and beeping the horn at people, looking like the lonliest dogger in town. Damned elastictrickery!

RRC V8 · Apr 21, 2011

Engine back in in the Range Rover, found out the head gasket's gone.

pete23 · Apr 21, 2011

soiled the rear with another womans cum

and ive only just got her out me workshop

RRC V8 · Apr 22, 2011

Can anyone recommend a good head gasket set for a 3.9 EFI Range Rover?

bluesticky1 · Apr 22, 2011

pete23 said:
soiled the rear with another womans cum

and ive only just got her out me workshop

Too much info there Pete!!!!

Clanforbes · Apr 22, 2011

pete23 said:
soiled the rear with another womans cum

and ive only just got her out me workshop

No pics it didn't happen

bluesticky1 said:
Not enough info there Pete!!!!

edited for accuracy

Clanforbes · Apr 22, 2011

Nothing done to it yet, but I just bought her a rear step and a snorkel.

instantsquid · Apr 22, 2011

Completely failed to remove any of the suspension bushes from the Series chassis. Feeling thoroughly demoralised at the moment. Will have another go later when my "mojo" has returned...

fishsponge · Apr 22, 2011

Cleaned the air filter again, in the hope that it has something to do with the "rushing air" noise I heard while under load late in my journey today...

The Mad Hat Man · Apr 22, 2011

bastid bloody landies

stripped back to P gasket again - water ****ing out worse than before - discovered a corrosion track from water gallery to bolt about 3mm wide and 1mm deep - no wonder it wont seal.

cleaned it all up and chemical metalled it - reassembly tomoz.

if this dont work its a new water pump to block housing

.

instantsquid · Apr 22, 2011

Stripped the Series rear axle down ready for cleaning, painting, rebuilding, etc. All looks okay.... apart from some rot in the strengthener.

John FHA · Apr 22, 2011

Put new steering pump on after old one fell apart. whoo hoo.

Ken Spooner · Apr 23, 2011

black hammerite on some of the interior at 7 this morning
took of some body panels checked them for rust and re-attached

concal · Apr 23, 2011

found a whacking great hole in rear wheel arch hant noticed it as i dont get in back door

The Mad Hat Man · Apr 23, 2011

Re did P gasket - 3 hrs

Seems to be holding

found source of (one) oil leak - cyclone filter O-ring not sealing - oil peeing down side of block. Does anyone know where I can get a 15-18mm x 3mm Dia O ring from?

fitted one from 200tdi tempararily.

bustersbus · Apr 23, 2011

The Mad Hat Man said:
Re did P gasket - 3 hrs
Seems to be holding

found source of (one) oil leak - cyclone filter O-ring not sealing - oil peeing down side of block. Does anyone know where I can get a 15-18mm x 3mm Dia O ring from?

fitted one from 200tdi tempararily.

Halfords?

Dartmoor Navigator · Apr 23, 2011

The Mad Hat Man said:
Re did P gasket - 3 hrs
Seems to be holding .

You know this really isn't helping

I on the other hand, thought about, then ignored ignored my p gasket for another day and went to Tesco instead

The Mad Hat Man · Apr 23, 2011

If yu can get yo motor up here, I will give yu a hand sometime.

What have you done to your Landie today.

New Member

New Member

Well-Known Member

Active Member

Active Member

Active Member

New Member

New Member

New Member

New Member

New Member

Well-Known Member

New Member

Active Member

Well-Known Member

New Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Similar threads