Other what have u done on ur disco today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Then ran the cb aerial lead from the transmitter to the rear corner pillar , unclipped the B pillar ran cable behind, then unclipped rear LH window surround and fed it finally to back corner. Never done anything like this before and was very nervous! The next step was drilling two holes and fitting the aerial reciever then connecting all the cables! Seemed to go ok! All fitted now and all panels back in place without any breakages thankfully! Apparently before incan turn on i need to do something with an SWR meter??
20210327_151020.jpg
20210327_151025.jpg
20210327_165219.jpg
20210327_165223.jpg
20210327_165944.jpg
20210327_163058.jpg
 
Fitted a new MAF I now get a reading on my Foxwell. After plenty of elbow grease wire brushing etc I've put a coat of Hammerite Krusty stuff on (yesterday) then a coat of Omnicote today, I'll do another tomorrow whilst I wait for my wheel stud to turn up.
Also painted the fr. brake dust shield & a couple of brake pipe brackets.
20210329_162609.jpg
 
Andy Warren said:
Fitted a new MAF I now get a reading on my Foxwell. After plenty of elbow grease wire brushing etc I've put a coat of Hammerite Krusty stuff on (yesterday) then a coat of Omnicote today, I'll do another tomorrow whilst I wait for my wheel stud to turn up.
Also painted the fr. brake dust shield & a couple of brake pipe brackets. View attachment 234450
Click to expand...
Looking good!!!
 
Got the new wheel stud & fitted that just had to grind a slight flat on the head.
There's a slight difference between the old & new, see pics but it went in fine & I torqued it up to 104 lb ft ok.
Fitted dust shield ready for new disc & caliper tomorrow.:)
20210330_173541.jpg
20210330_173342.jpg
20210330_182807.jpg
 
Took the sump off, and gave it a good clean. Removed the old spigot bearing and crank seal. Used a slide hammer with a hook adaptor on it, and it took 30 seconds to get out. Replaced both..

New sump gasket ordered... and will refit Thursday.
20210330_190442.jpg
20210330_175139.jpg
 
Ye no 50mm no cutting required. Shunted my front bumper back abit the other week but it normally finishes flush with the arches
 
Thanks, just waiting for the paint to dry on the jubilee clip for the top, can't belive they just bung a silver one in with!
 
You must log in or register to reply here.

Similar threads

K
What money should I be asking?
2
Replies
27
Views
4K
Karls
K
F
What have you done with your series today?
Replies
4
Views
1K
Frustrated Seriesist
F
L
SOLD - Land Rover Ninety (Defender 90) 300TDi Auto soft-top
Replies
9
Views
4K
mondifa
M
I
Disco 2 Central Locking Issue on a 1999 Disco 2
Replies
5
Views
999
sierrafery
sierrafery
R
Oh dear, what have I done......?
2 3
Replies
47
Views
6K
Rallymantony
R
Back
Top