tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
from inside the vehicle you could see very little and the wheel well wasnt wet, the water never got that far
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 12,620
- Location
- Sud ouest France !
That was a good discovery my good man, at least you can sort it. Weather permiting of course.
- Posts
- 12,620
- Location
- Sud ouest France !
That was a good discovery my good man, at least you can sort it. Weather permiting of course.
- Posts
- 12,620
- Location
- Sud ouest France !
Stupid site activity again!!
- Posts
- 19,292
- Location
- Buckinghamshire, UK. ('95 DT)
That's bad. Was it stored in the Dead Sea?
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
No Buckinghamshire I believe ,there is a lot of crap down that way
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
I am more used to seeing holes like that cut out of a RRC more than a P38. Chassis seems like it’s got good dose of surface rust probably caught in time, not sure about the notchy/crumbly bit
- Posts
- 6,165
- Location
- North Manchester
Treated her to a solar charger to keep the battery topped up till I finish fixing her. Hopefully it will work.
3D printed some bits to tidy everything up. Instructions said to put a bulb across the load but I don't think it needs it.
Not wired the (Australian) switch up yet
3D printed some bits to tidy everything up. Instructions said to put a bulb across the load but I don't think it needs it.
Not wired the (Australian) switch up yet
Datatek
Well-Known Member
- Posts
- 44,864
- Location
- Near Poitiers SW France
That's a complicated charge controller, what size is the panel? It looks like a 20 watt job which is what I use.
- Posts
- 6,165
- Location
- North Manchester
Yes 20 watt. Don't know anything about controllers but the reviews said this should be fine.
Datatek
Well-Known Member
- Posts
- 44,864
- Location
- Near Poitiers SW France
It's a good controller.
I went for a cheaper, simpler one with less to go wrong as I needed 6 of them.
- Posts
- 6,165
- Location
- North Manchester
Datatek
Well-Known Member
- Posts
- 44,864
- Location
- Near Poitiers SW France
I pay €6,50 for mine including postage.It was £12 on Amazon
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Is same dvm I ordered.
Still no sign of delivery yet
Still no sign of delivery yet
Datatek
Well-Known Member
- Posts
- 44,864
- Location
- Near Poitiers SW France
Looks much like one of the DVM's I have. Good bit of kit.
£9.99 from China. Ok but started losing pixels after a few months. 12v could be 12000v..lucky dip.!
Datatek
Well-Known Member
- Posts
- 44,864
- Location
- Near Poitiers SW France
Not the same as mine then but a look alike. Had mine for years with no problem apart from a broken test lead.
Guess it's 'gets what you pay for'..
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
