Urgent help please.

Morning Everybody, Just took our Freelander 2.0l td 55reg, out with permission of the hubby.

And the ORANGE ENGINE LIGHT WITH AN ! IN IT FLICKED ON & OFF!!

I also think car went into limp home mode (safe mode).

Any help would be much appreciated.

Also any idea who/where to take this 4x4 in the Norwich area.

There is a good place just off vulcan road, JSF tel 405801.
JSF 4x4 Ltd
Hope this helps.

Many thanks, off to our mechanic to read the code, but, as it has flicked off again, we may not have a code to read!

Soory cant be more help, but i have only just bought my first disco so got a lot to learn.
Good luck
Bob

Boxerboy65 said:

Many thanks, off to our mechanic to read the code, but, as it has flicked off again, we may not have a code to read!

Click to expand...

Any fault code will normally be stored in memory until they are cleared via a diagnostics computer.

Not looking forward to the out come of the code.
Only just got 4x4, so mega upset!

Bet it will be a serious problem.

I think it could be a problem with the flux capacitor,make sure you ask the garage about it.

daiengland said:

I think it could be a problem with the flux capacitor,make sure you ask the garage about it.

Click to expand...

Which type of flux capacitor do these use, the one one my evo was never any bother PMSL

it's most likely yer heisenberg compensator mate

Freelaner said:

it's most likely yer heisenberg compensator mate

Click to expand...

oh the tears these cause, betteroff having one that works on thermal expansion !!!

rigpig said:

oh the tears these cause, betteroff having one that works on thermal expansion !!!

Click to expand...

replace the whole unit or you'll end space time , and you'd get into trouble for that

Freelaner said:

replace the whole unit or you'll end space time , and you'd get into trouble for that

Click to expand...

Not if you adjust the winkle screw to postion 11.5

Take all the bulbs out, no more orange lights, problem solved, SIMPLES!!

I think youre right.

rigpig said:

Not if you adjust the winkle screw to postion 11.5

Click to expand...

when it only goes up to 10.37, sure

Freelaner said:

when it only goes up to 10.37, sure

Click to expand...

That was the early model mate, the later ones can be set to 13.13 if required.

rigpig said:

That was the early model mate, the later ones can be set to 13.13 if required.

Click to expand...

i reccons its the overhead fuffle valve got a bit of dark matter stuck in the inlet

the **** that gets cought in wormholes dunt arf fook these up

fuffle valve de-guassing fluid, works everytime.

used to have them in series impulse enjuns

Freelaner said:

fuffle valve de-guassing fluid, works everytime.

used to have them in series impulse enjuns

Click to expand...

You may have a point there.

Hi Everybody.

Problem solved.

We had to codes that came up, both relating to fuel pressure.

We found a bare wire on the sensor under the bonnett.

BUT THEN CAR WOULDNT START!

my mechanic checked fuel pump, and it wasnt picking up on the ignition, so he hit it with a hammer!

Car started straight away.

LOL