vaughanwilson
New Member
- Posts
- 8
- Location
- Cumbria - God's country
My 95 2.5 TD RR, after being stood for 3 months unused (I was undergoing radiotherapy treatment) now wont rise from access mode.
Using EASUnlock & also Blackbox faultmate does not show up any ECU faults. The software also shows that the front and rear valves are switching when the dashboard height switch is operated . The height sensors are working with the engine running I jacked up the rear using the tow bar and the change of height was shown by the rear sensors. Co-incidentally, with the rear jacked up the front of the RR would rise up and down when I pressed the dash control to raise / lower the vehicle (front height sensors showed the change in height). After I lowered the rear end of the RR off the jack the front would not lower until I switched off the ignition and locked the vehicle. Then it settled back down to access mode height.
Anyone any ideas what the problem could be?
Using EASUnlock & also Blackbox faultmate does not show up any ECU faults. The software also shows that the front and rear valves are switching when the dashboard height switch is operated . The height sensors are working with the engine running I jacked up the rear using the tow bar and the change of height was shown by the rear sensors. Co-incidentally, with the rear jacked up the front of the RR would rise up and down when I pressed the dash control to raise / lower the vehicle (front height sensors showed the change in height). After I lowered the rear end of the RR off the jack the front would not lower until I switched off the ignition and locked the vehicle. Then it settled back down to access mode height.
Anyone any ideas what the problem could be?