- Posts
- 33,600
- Location
- North Shropshire
That's strange, even did it as a test on mine once, worked fine
p38a
- Thread starter carper10
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Depends on the age of the car and the firmware version of the BECM, EKA cannot be entered with Nanocom on all versions. Also, EKA cannot be turned off if the BECM is asking for the code to be entered.
awkwardbob
Well-Known Member
- Posts
- 578
- Location
- Glasgow
What firmware version is your BECM ?
mine is a late ‘97 car with v39 firmware and it allowed entry of the EKA as described above -I did have to check with JLR as the wrong EKA was written in the handbook
mine is a late ‘97 car with v39 firmware and it allowed entry of the EKA as described above -I did have to check with JLR as the wrong EKA was written in the handbook
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Marty and I went through about 20 BECMs of different ages one afternoon and came to the conclusion it must only be early 1994 cars that it doesn't work on.
Hi Guys posting for help on this thread I’m Warwickshire based does anyone know anyone who can reset my ECU to BECM I have the code I have a p38 2.5 diesal 2000/1 year it’s none starter at Ettington in Warwickshire I’m happy to pay for the reset and travel . Engine immobilised won’t start . Ettington 4x4 says needs to get ecu to recognise the code ?
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Posting the same problem twice will not win you any friends nor will it get a faster response. I have answered on your other post.
- Posts
- 12,628
- Location
- Sud ouest France !
What has happened to get to this point?
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Im not reading the other thread. I bet they’ve told you how to do it without diagnostics already.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Engine Management security code? Need proper diag like Nanocom to do that. That won't have a message on the dash though. EKA might. Open the door every 2 attempts to stop it timing out. EKA needs all microswitches in the door working.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Engine management security code on the diesel is fixed and if sync with the BECM is lost you may get "Engine disabled" on the dash, on the other hand, it may just not start.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
No message on mine. Cranked but no start.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Lots of different firmware levels so I'm not entirely sure, but the project car used to come up "Engine disabled" and it needed diagnostics to rewrite the EDC code to the BECM. As you say, crank but no start.
Similar threads
