Nanocom Results / Rough Starting

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
From all this thread which i followed from the beginning at this point i'm not convinced at all that it's air in the system cos if it was the symptom should have not occured after a purge sequence IMO
 
sierrafery said:
From all this thread which i followed from the beginning at this point i'm not convinced at all that it's air in the system cos if it was the symptom should have not occured after a purge sequence IMO
Click to expand...
Even if the injector copper washers haven't sealed? In that case, that's the next thing that's getting changed!
 
Again? :eek: ...IMO in any case if the problem is air in the system after a purge the engine should start and run normally cos that's what the purge does, it eliminates the air if there is any
 
Was this log recorded at the beginning of the trip immediately after start up and does it cover the whole 30 minute driving? ... i think the defender ECU doesnt get the VSS signal for road speed cos the speedometer is driven by that transducer on the TB not by an ECU like on a D2

record a log when the engine is up to operating temperature cos i've seen some suspect readings there
 
sierrafery said:
Was this log recorded at the beginning of the trip immediately after start up and does it cover the whole 30 minute driving? ... i think the defender ECU doesnt get the VSS signal for road speed cos the speedometer is driven by that transducer on the TB not by an ECU like on a D2

record a log when the engine is up to operating temperature cos i've seen some suspect readings there
Click to expand...

This is just a short trip including startup, a few minutes at most, as I haven’t bothered MOT’ing it I’m a bit limited how far I can go. I had never noticed before that the road speed was missing from the log, I’m sure I can see it on live data and from memory I’m sure I can on Lynx too.

EDIT: Nanocom does not display the road speed, the speedo does though
 
Last edited:
Multimeter on battery is showing 14.5ish when engine running, varies from 13.5 to 14.6 when driving

Ran some jump leads from the battery negative to chassis/earth and another jump lead from battery negative to ecu earth and readings are a lot better. Not sure if this will help with the starting issue or not....
 
Hi Tom
Just to let you know that you atebta alone with your rough start. Mine runs crappy for a short while when first starting before running perfectly
 
tom1979 said:
L


It smokes less than it did before the remap, dynachip knows what he’s doing. It only smokes when I should have changed down a gear. If it did it all the time I would be concerned.
Click to expand...

It should not smoke at any stage unchipped, chipped a little can be expected.
 
You must log in or register to reply here.

Similar threads

MAF Diver
Disco 2 Nanocom/RAVE manual is wrong: adjusting windows after removing key and opening a door?
Replies
4
Views
429
MAF Diver
MAF Diver
JockHiltz
TD5 Hard Starting
2 3
Replies
49
Views
4K
KISSMYAURA
KISSMYAURA
F
ECU swap config Aircon and ABS on nanocom?
Replies
4
Views
1K
fumiyasu
F
DefendingLancashire
300TDI Four-parter: brake wear, lift pump / fuel filter, turbo, and bushes / squeaking
Replies
13
Views
499
miktdish
miktdish
T
TD5 Defender Starting Problems
Replies
16
Views
2K
TCI Defenders
T
Back
Top