Hertfordshire Lanes?????

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I Decided to go and do a few lanes today...found one between Hemel and Bovingdon, right next to cuffley camp if anyones done that before? Got a little tight in places. I was very tempted to do the ford at the Mill in Harpenden/Redbourn but couldnt see the bottom, was pretty deep with all the rain this morn....decided to be on the safe side and leave it not having a snorkel. Finally went to the lane which comes out just down the road from the crooked chimney...nice and wet and slippy...when did the rutty bit at the end get flattened?! It was completely flooded.

Rob


next to cuffley camp? thats my neck of the wppds that is, i never donr that one before? nor noticed it n i drive past it every day?

i'm presuming of course this is cuffley camp in cuffley, nr cheshunt end?

dan
 
next to cuffley camp? thats my neck of the wppds that is, i never donr that one before? nor noticed it n i drive past it every day?

i'm presuming of course this is cuffley camp in cuffley, nr cheshunt end?

dan

Sorry Got it wrong...It wasn't cuffley camp.......it was Phasels Wood!:doh:
 
Well, went out with the full intention of doing a few but got caught short when a visitor from afar and long lost relative dropped in unannounced!

Had to cancel the evening and come home... still it was nice to see me old mate again!
 
evening Dan. Rob and I are going out on Sunday 28th for some gentle stuff as we both have standard Discos. Do you want to join us?
 
OK... 2 dizzy caps; 2 rotor arms; 4 plugs (all they had in stock); 8 leads... £153.00!!!

Bloody 'ell that hurt!

Mind you... you don't drive my motor now so much as pilot it :)
 
got all the back half done now, got new discs and pads for the front and gota get some springs to match the new ones on the back after i done the rest of the mot work
PICT0003.jpg

1PICT00051.jpg

does anyone have any tips on getting the old disc off the hub, took me nearly 3hrs to get 1 of the bastids off :mad:
 
breaker bar, vice, make sure they are torqued up to the correct figure, this should not be guessed!!! Kin tight is not good enough! Jai
 
I'm sure when I got a set of cheapos last year they were in a plain box with mintex stamped in back of the metal part of the pad. Looking good Jamie keep up the hard work!
Did you ever get to the bottom of the bearing problems??

Jai
 
Back
Top