Disco Tray back build

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Looking good, I'm also surprised how much difference this makes!

I'm fairly certain Gwyn Lewis sells the wide angle a-frame joint already pressed into the bracket to save you struggling if you don't have a decent hydraulic press yourself...
 
I found a 12ton press (a small one basibally) to be ok but had to hammer on the housing to shock it to get it to move the ball out

Using a 50ton or similar is a sheer delight though tbh
 
You'll need heat then!

Anyway, if you've got a spare it's not too bad but even so these are ridiculously seized sometimes

Remove the retaining bolts and slice the ears off the ball joint plate

Rest the bracket on some sturdy wood or I beam on the portion where you removed the ears

Then proceed to beat that bad boy with a sledge

Air chisel may help to destroy the joint so you can remove it in pieces but meh

Akso a brave mate to steady everything up would be helpful :)
 
On the eBay page it isn't listed as the x eng wide angle ball but just adjustable a frame joint. It does say it has more articulation angle the same as it says on the webpage. I'm not sure if there's any difference between the two to be honest?
 
You must log in or register to reply here.

Similar threads

S
Disco 1 Disco 1 Rust repair prep
2
Replies
20
Views
2K
sv_dOnut
S
xDParis64
Rear Door Questions.
Replies
12
Views
576
xDParis64
xDParis64
SkeetRover
Disco 2 Sunroof opening misshapen??
Replies
3
Views
764
SkeetRover
SkeetRover
LukeyT
Disco 2 Disco 2 Electrical Issue Interior Lights, Radio, Heater Controls and Immobiliser
Replies
6
Views
899
LukeyT
LukeyT
B
Smart Key Issue - Disco 4
Replies
0
Views
1K
BourneFree
B
Back
Top