- Posts
- 2,427
- Location
- Isle Sheppy
Just put all air bag connectors back under the seat reconnect battery and getting code 008 drivers air bag open circuit permanent what’s this mean before I get a face full of air bag cheers
P38A Air bag
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,884
- Location
- Near Poitiers SW France
Broken wire or corroded connector not making contact. The side airbags will be well out of date, I removed mine and fitted resistors to fool the ECU into thinking they are still there
- Posts
- 2,427
- Location
- Isle Sheppy
I’ve I new how to do that I probably would but not good with electrics
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
- Posts
- 2,427
- Location
- Isle Sheppy
Cheers
- Posts
- 33,600
- Location
- North Shropshire
Yes the airbags will be past their best before date, but so what? Why take them out?
At worst they don't do anything, at best they work as intended. Is there a down side?
At worst they don't do anything, at best they work as intended. Is there a down side?
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Might just go off while driving. I think that is unlikely but no-one has had airbags this long before so it is untested. Mine's older than yours though. I will let you know when a pillow explodes in my face or check the obituary column.
Here lies Grrrrrr,
Poor old fellow,
Crashed off the road
When his airbag billowed.
- Posts
- 33,600
- Location
- North Shropshire
Never heard of an old airbag going off on its own.
As far as i know, the charge doesn't go unstable through age, though might misfire like a damp squib
As far as i know, the charge doesn't go unstable through age, though might misfire like a damp squib
Datatek
Well-Known Member
- Posts
- 44,884
- Location
- Near Poitiers SW France
Wrong resistance value for the side airbags, I found it needed 1.5 ohms to work.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
thats ok I knew you would point In the right direction
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
- Posts
- 2,427
- Location
- Isle Sheppy
The 3 resistance no good then I will re order the 1.5 cheers
Datatek
Well-Known Member
- Posts
- 44,884
- Location
- Near Poitiers SW France
Two 3 ohm resistors connected in parallel = 1.5 ohms
- Posts
- 2,427
- Location
- Isle Sheppy
So I could use one in each seat I’m lost the language your talking data may as well be talking to a house brick when it comes to electricity I’ve downloaded pages of diagrams of becm to drivers seat outstation been looking at them and still none the wiser I swear the dog sitting next to me on the couch understood them more than me
