What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Refitted the mud terrains and camel cut the back arches to stop the tyres ripping against them.
The clutch release bearing was sorted last weekend (hurrah) and to try and prevent it happening again I took off the flat plate on the bottom of the bell housing and refitted it with a lot of sealer.
Hopefully no more muddy water entering the bellhousing and no more clutch problems ;)
No where's the mud at???? :D
 
Took rear passenger door off, fitted new passenger door relised striker wunt fit took off new door and put old one back on while I source a different plate
 
Couple of days ago now, but I fixed the bodywork damage from laning by grabbing hold of th bent bit, and pulling.....


....is this the correct way to fix a landy, or was I wrong not to use a hammer ?? :D
 
cleaned out intercooler and inlet manifold and all associated hoses,and managed to take a piccy of it,might even get round to posting it on here
 
Removed the rear half shafts from the white bus tae find thur nae better than the green ones'. Got a bit bored while havin' a 'few' wife beaters so decided tae clean up a panhrd rod and rear door internal shuttin' handle;)
 
yes well up early, but trying not to watch TV as i dont want to know the result of the MOTO GP!! i will watch it lunch time with a sunday roast (KFC)!!
Off to tesco for some brekie now :)
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
538
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
632
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
915
Knappster
Knappster
Mooky
Replacing thermostat
Replies
14
Views
564
Mooky
Mooky
I
Re-coding of ABS Module after repacement
Replies
10
Views
990
invisible999
I
Back
Top