What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
realised the release bearing i fitted to the clutch in the disco at the week end rumbles like a tw#t hope it will settle down, coz i don't want to take the injun out AGAIN!

please tell me it will settle down as it beds in!

hope it wasnt a britpart bearing cos it'll make you wish you left the old one in
 
hope it wasnt a britpart bearing cos it'll make you wish you left the old one in



no it was borg an becker or a.p driveline as it's called now
the brother in law put a ****part one in an his is quiet as a mouse
mine sounds really grumbley:eek:
 
is it dry and maybe picked up a bit of grit ? - never had a BB/AP sound like that

least you know how it all comes apart now :)
 
is it dry and maybe picked up a bit of grit ? - never had a BB/AP sound like that

least you know how it all comes apart now :)


no it's not dry!
the brother in law used copper slip on the bearing and face, he even said it felt a good quality bearing,
but his ****part one is quiet an mine is noisey as fook
just shows you don't get what you pay for:eek:

do ya think it'll settle in?
 
Today ah prepped the 'inside' and a couple of bit's of the 'outside' of the bulkhead and sprayed it with some stonechip stuff....

Bulkheadmods040.jpg


Bulkheadmods041.jpg



and to help dry it out a bit, ah stuck it and a heater in the back of the bus...

Bulkheadmods039.jpg


Will try and get the front finished tomorrow
;):D
 
Today ah prepped the 'inside' and a couple of bit's of the 'outside' of the bulkhead and sprayed it with some stonechip stuff....

Bulkheadmods040.jpg


Bulkheadmods041.jpg



and to help dry it out a bit, ah stuck it and a heater in the back of the bus...

Bulkheadmods039.jpg


Will try and get the front finished tomorrow
;):D



lookin good buster!
when will the landy be finished?
 
what stone chip paint do you use buster want to do my footwells and bulkhead etc
It was stuff I got from my local Partco a wee whiles back bj for doin' inside the rear tub, it's made by Bodyline. I thinned it down a little with standard thinners and used a normal spray gun and compressor to stick it on with so it is smooth;)
 
Back
Top