What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
fitted my thermostat housing with new gaskets and thermostat. found that my modification of a bleed screw in the top doesn't work so used the old top then fought to get the air out. might still have some in there but majority should be out now. also took a pic of the winch bumper but photobucket is taking ages on my phone so ill put that up later for your opinions
 
her we go I think it sits too low what do you think

oh and I noticed that although I have renewed the leak off pipes and used clips I still have a leak between 2 and 3 could this be the copper washers on the banjo bolts and what size are they so I can get some ready to swap over
 
Manged to get the flap disc going, sheltered under the car from rain and cleared some surface patches of rust on the chassis.

Also had a bash at the doors before it got dark. Hoping the forecast for tomorrow holds and allows some major progress to be made.
 
Started to strip down the rear tub, removed the bottom strips and the capping etc ready to blasted and galved

also removed the side panel, so i can swop it with one as i want the filler neck in the original place
 
Was involved in a minor collision in my 90 today but not at fault, no injuries, and no damage done to mine but the other guy had part of his front bumper torn off his zafira by my tyre :D
 
I've been busy with Dinitrol this afternoon. I sprayed some more into my door bottoms, and into the box sections on the bulkhead. On trying to undo the door hinge bolts to gain access I felt the depressing feeling of captive nuts liberating themselves. I'll have to wait until I get some more and then have a go at drilling the heads off the old screws. Plenty of Dinitrol in the bulkhead though, via some handy little rubber caps on the A post. I sprayed the bottom part of the footwells too, inside and outside, and refreshed the inside of the chassis at the front as well. I dropped the removable crossmember and Dinitroled the mating faces where it presses against the chassis. Feels much better.
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
536
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
629
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
910
Knappster
Knappster
Mooky
Replacing thermostat
Replies
14
Views
555
Mooky
Mooky
I
Re-coding of ABS Module after repacement
Replies
10
Views
988
invisible999
I
Back
Top