gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
more work on the chassis, ready for welding tomorrow
hi.
where those cracks end in the fresh metal,drill a hole to take the stress out of the metal before you weld it up.
What have you done to your Freelander today
- Thread starter Freelaner
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
hi.
where those cracks end in the fresh metal,drill a hole to take the stress out of the metal before you weld it up.
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
Hippo
Lord Hippo
- Posts
- 53,848
I didn't wash the engine but have done previously.ok,but what about the motor???
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
I didn't wash the engine but have done previously.
lol.:tea:
baptista
Active Member
- Posts
- 678
- Location
- Lisbon, Portugal
ok, will do, thanks for the advice. I am not an experienced welder.
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
no problem,i see that there are a lot of cracks,why not cut it all out and replate it properly??
baptista
Active Member
- Posts
- 678
- Location
- Lisbon, Portugal
after the cracks are welded I plan to weld a plate to it
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
ok,thats great.good luck.
baptista
Active Member
- Posts
- 678
- Location
- Lisbon, Portugal
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
thanks, I'm going to need it
preparation is the key,you will be fine.:tea:
sparkysbandit
Active Member
- Posts
- 360
- Location
- Newcastle upon tyne
Bought a nice stainless steel sport back box today....hope to get it fitted this week
duncanpage4
Active Member
- Posts
- 455
- Location
- East Sussex
sparkysbandit
Active Member
- Posts
- 360
- Location
- Newcastle upon tyne
weirdbeardmt
Active Member
- Posts
- 193
- Location
- Here and there.
I've just picked up a 2003 V6 with a medium sized list of issues. So over the last few days have investigated/sorted/fixed:
* Passenger side electric window. Fortunately just a dodgy switch as opposed to anything worse, so new switch on order.
* Sunroof - was dead. Switch was disconnected - for a reason! Would get half way and jam. Would come back and jam. Bizarrely though all rails were intact, although a bit rusty. So with a bit of adjustment it's now alive and well. Greased up the runners though to try and preserve them as long as possible.
* Replaced the rear HL brake light with a loan part. The bulb wasn't just gone, it was completely exploded/melted.
* Fixed lower nearside brake light. Water had got in to the light cluster and rotted the bulb holder. Found one on an earlier FL1... although turns out the indicator holder are different between the early FL1 and the slightly later (not F/L) FL1... so had to splice the two looms together.
* The car came with a Parrot bluetooth thing that worked but was installed incorrectly. Reinstalled and then flashed the firmware to the latest version, so now works with the iPhone.
* Found a nice big puddle of water in the boot which the HK sub was basting in. Dried that out... and then discovered it had filled up again! So need to investigate more as to where all the water is and potentially fix seals.
* Used a DEC SuperScan Solo to clear some of the fault codes and clear lights off the dash. Will see if they reappear...
* Oh, and yeah. Filled the coolant. ( )
* Passenger side electric window. Fortunately just a dodgy switch as opposed to anything worse, so new switch on order.
* Sunroof - was dead. Switch was disconnected - for a reason! Would get half way and jam. Would come back and jam. Bizarrely though all rails were intact, although a bit rusty. So with a bit of adjustment it's now alive and well. Greased up the runners though to try and preserve them as long as possible.
* Replaced the rear HL brake light with a loan part. The bulb wasn't just gone, it was completely exploded/melted.
* Fixed lower nearside brake light. Water had got in to the light cluster and rotted the bulb holder. Found one on an earlier FL1... although turns out the indicator holder are different between the early FL1 and the slightly later (not F/L) FL1... so had to splice the two looms together.
* The car came with a Parrot bluetooth thing that worked but was installed incorrectly. Reinstalled and then flashed the firmware to the latest version, so now works with the iPhone.
* Found a nice big puddle of water in the boot which the HK sub was basting in. Dried that out... and then discovered it had filled up again! So need to investigate more as to where all the water is and potentially fix seals.
* Used a DEC SuperScan Solo to clear some of the fault codes and clear lights off the dash. Will see if they reappear...
* Oh, and yeah. Filled the coolant. (
)
Last edited:
jedi
Well-Known Member
- Posts
- 2,327
- Location
- A Galaxy far far away.......
Kicked my hippos tyre...my amigos are back but without red brake warning light aftet being ok for 24 hrs.......
GrumpyGel
Well-Known Member
- Posts
- 26,393
- Location
- Christchurch, New Zealand
I've just picked up a 2003 V6 with a medium sized list of issues. So over the last few days have investigated/sorted/fixed:
* Passenger side electric window. Fortunately just a dodgy switch as opposed to anything worse, so new switch on order.
* Sunroof - was dead. Switch was disconnected - for a reason! Would get half way and jam. Would come back and jam. Bizarrely though all rails were intact, although a bit rusty. So with a bit of adjustment it's now alive and well. Greased up the runners though to try and preserve them as long as possible.
* Replaced the rear HL brake light with a loan part. The bulb wasn't just gone, it was completely exploded/melted.
* Fixed lower nearside brake light. Water had got in to the light cluster and rotted the bulb holder. Found one on an earlier FL1... although turns out the indicator holder are different between the early FL1 and the slightly later (not F/L) FL1... so had to splice the two looms together.
* The car came with a Parrot bluetooth thing that worked but was installed incorrectly. Reinstalled and then flashed the firmware to the latest version, so now works with the iPhone.
* Found a nice big puddle of water in the boot which the HK sub was basting in. Dried that out... and then discovered it had filled up again! So need to investigate more as to where all the water is and potentially fix seals.
* Used a DEC SuperScan Solo to clear some of the fault codes and clear lights off the dash. Will see if they reappear...
* Oh, and yeah. Filled the coolant. (
Very satisfying to get that lot sorted, well done
sparkysbandit
Active Member
- Posts
- 360
- Location
- Newcastle upon tyne
Found a nice big crack in the exhaust manifold around the cat...happy days
Similar threads
