Lazydave
Well-Known Member
- Posts
- 193
- Location
- Birmingham
Oil and filter change.
Other what have u done on ur disco today
- Thread starter gstuart
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 1,512
- Location
- Somerset (but I'm a Landanna)
Took it to Kwik Fit for 5 tyres. They look great, but unfortunately the spare no longer fits in its hole. 
Will probably get a swingaway carrier if I can find one for a reasonable price.
Will probably get a swingaway carrier if I can find one for a reasonable price.
LANDiscoNewby
New Member
- Posts
- 9
- Location
- Rugeley
ian mitchell
Well-Known Member
- Posts
- 405
- Location
- bradford
looked at it, too busy decorating to do anything with it.
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
Reconditioned and then charged the battery since it’s been sitting for over a month.
- Posts
- 2,061
- Location
- Hertfordshire
Fitted new rear bump stops & three rubber grommets to the eng. cover as they were split/perished, checked tyre pressures & all the fluid levels (only the T/Box oil needed a top up). Checked the fairly new inj. harness/wiring/ECU plugs for oil, thankfully all clean on that front so all ready for the 400 mile round trip to Wales tomorrow, just not looking forward to the fuel bill.
.
Jasonmichael
Well-Known Member
- Posts
- 257
- Location
- Oldham
Well I've been trying to get my D1 V8 back on the road for 3 yrs now. But after 2 major surgeries on my spine in 2020 & 2021, Covid nearly killing me last year & another major surgery on my spine last Friday I'm struggling to get anywhere with it. Its had (before I was crocked) Rear axle rebuild, full shocks & springs, transfer box refurbed, auto box refurbed, engine rebuilt, offside inner wing sorted, full chassis rubdown & repaint, new swivels & associated seals. Getting really bored doing nothing so hobbled to the garage this aft, had a look at the old girl in a sorry state and wrote a list of things to do to finish her..........
Lazydave
Well-Known Member
- Posts
- 193
- Location
- Birmingham
New battery. Old one was LR and 7 years old so did well.
Two new front tyres.
Two new front tyres.
zzr1200
Well-Known Member
- Posts
- 1,862
- Location
- Chesterfield, Derbyshire
My 2001 disco failed the MOT on anti-roll bar ties and front axle knuckle ball joints last week, I replaced all 4 ball joints and anti-roll bar tie rods.
Not a bad job really just done a bit differently....
Now I've done the job once, it's time to make a proper hydraulic removal/installation press...
Not a bad job really just done a bit differently....
Now I've done the job once, it's time to make a proper hydraulic removal/installation press...
Attachments
Last edited:
- Posts
- 1,512
- Location
- Somerset (but I'm a Landanna)
Fitted a rear carrier to my 2010 D4 this weekend.
Was thinking about a roof rack but worried the TV aerial would be in the way, but when I went to measure it I noticed the panoramic glass has cracks which are spreading.
I drive 4 cars so probably cheaper to not go through insurance.
Got some quotes - Autoglass seem to be £300 cheaper than National Windscreens.
Was thinking about a roof rack but worried the TV aerial would be in the way, but when I went to measure it I noticed the panoramic glass has cracks which are spreading.
I drive 4 cars so probably cheaper to not go through insurance.
Got some quotes - Autoglass seem to be £300 cheaper than National Windscreens.
- Posts
- 2,061
- Location
- Hertfordshire
D2 failed the MOT yesterday on O/S fr. suspension spring broken, although I haven't taken the wheel off I have turned it from lock to lock but can't see where it's broken. Two new springs on order & I've had some turrets since last Sept. to fit anyway so I'll do them altogether. Otherwise no advisories
on O/S fr. suspension spring broken, although I haven't taken the wheel off I have turned it from lock to lock but can't see where it's broken. Two new springs on order & I've had some turrets since last Sept. to fit anyway so I'll do them altogether. Otherwise no advisories
- Posts
- 760
- Location
- Staffordshire
Dropped the D2 off at Replacement chassis repairs for extended 1/2 chassis replacement!
Should be done for next Saturday
Should be done for next Saturday
- Posts
- 2,061
- Location
- Hertfordshire
I paid £1100 for my 1/4 chassis to be done last month but I'm well chuffed with it (just got to find time to paint the centre bit ), what sort of money for the 1/2 to be done if you don't mind me asking.
for my 1/4 chassis to be done last month but I'm well chuffed with it (just got to find time to paint the centre bit ), what sort of money for the 1/2 to be done if you don't mind me asking.
- Posts
- 380
- Location
- Cheshire
- Posts
- 760
- Location
- Staffordshire
I paid £1100
been quoted £1800 so fingers crossed it stays around there lol
- Posts
- 2,061
- Location
- Hertfordshire
That sounds a like a fair price considering there's a lot more work involved. Do/will they treat the inside of the chassis once it's done ?
- Posts
- 760
- Location
- Staffordshire
They state the chassis is sprayed with a black etch primer and under sealed with Schulz.
I will probably get some waxoyl on the inside myself to be safe
- Posts
- 380
- Location
- Cheshire
Fitted short roof rails to the D3
