Other what have u done on ur disco today
- Thread starter gstuart
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Oh No.....................
I knew there was a reason I had a pot of that in my garage....Just in case.....LOL
Cheers
I knew there was a reason I had a pot of that in my garage....Just in case.....LOL
Cheers
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
biketeacherdave
Well-Known Member
- Posts
- 4,885
- Location
- south east london
Nothing nut must fix the drivers heated seat its getting chilly
- Posts
- 6,165
- Location
- North Manchester
Started replacing the TD5 injector seals, all was well until the last injector clamp bolt snapped
hopefully new bolt will be here Tuesday.
hopefully new bolt will be here Tuesday.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Started replacing the TD5 injector seals, all was well until the last injector clamp bolt snapped
ooops, surprised, as they are not a high torque setting.
Cheers
- Posts
- 6,165
- Location
- North Manchester
I think someones had a go at it in the past, my local Landy guy broke one a few weeks ago changing no3 injector.
Feathers McGraw
Well-Known Member
- Posts
- 2,780
- Location
- Cumbria
Finally evicted the spider from the driver's door mirror. Probably sneaked back again by now.
Feathers McGraw
Well-Known Member
- Posts
- 2,780
- Location
- Cumbria
Doublepost damn flaky mobile signal.
1988smithy
Well-Known Member
- Posts
- 4,044
- Location
- West midlands
Getting a bit of judder on taking up drive in 1st gear since off road course at p'boro, so took the Bell housing drain plug out, nowt come out.
Had a look at rubber coupling on rear prop, reckon it needs changing? Does feel like judder is coming from the back. Can't feel it through the clutch pedal.
Hope it ain't DMF starting to break up
Had a look at rubber coupling on rear prop, reckon it needs changing? Does feel like judder is coming from the back. Can't feel it through the clutch pedal.
Hope it ain't DMF starting to break up
Attachments
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
If you do change it, Make sure to fit the replacement in the correct orientation. Although I do not know if that is the cause of your judder.
Cheers
1988smithy
Well-Known Member
- Posts
- 4,044
- Location
- West midlands
There's arrows on the new ones I've looked at, are they to line up with or point in a certain direction? I'll take plenty of pics before I take the old one off
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
1988smithy
Well-Known Member
- Posts
- 4,044
- Location
- West midlands
Lol edited, fat fingersGlad you noticed.................
Cheers
brian47
Well-Known Member
- Posts
- 8,867
Yep, there are little arrows on the outside which should point towards the flange. You're well advised to use a GKN replacement coupling and new bolts and nuts, they're usually included in the pack.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
I'll take plenty of pics before I take the old one off
Worst case, it has a drawing of it in the workshop manual.
Cheers
