- Posts
- 33,600
- Location
- North Shropshire
It's towing in slightly on the front i think, but nothing major. Been meaning to get it done though i don't see it's bad enough to cause a problem
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
So with toe in the front of both wheels are pushing in at the front against each other so when you hit the water the opposite wheel will be pushing it further into the puddle, a tyre pushing against the opposite tyre + weight of a motor + a driven axle too its easy to see why it pushes the tyre to feel like its skimming the surface funny,
id personally be getting alignment sorted before chasing changing tyres, yes some are better then others iv done mix and match on tyres and new and olds grippy and some not so grippy on the same axle and all sorts over the years and found alignment has more effect the way your describing hitting puddles that way then tyre brand
Scotiawhiskers
Well-Known Member
- Posts
- 877
- Location
- Manchester
Caught up with friends and got lost in the backstreets of Grimsby. Fuelled up, 19.3mpg for almost 200 miles with quite a bit of idle or stop start crawling involved. Happy with that. Reset the computer after the stop and trip back to hotel got as good as 22.7mpg avg and range increase from 360 to 520+ miles before we stopped.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Is that not dot 5?
- Posts
- 33,600
- Location
- North Shropshire
No. Apparently it's still glycol based like the normal stuff, just has the word synthetic on the bottle. Supposedly just a higher boiling point and fully compatible from everything I've read.
Then there's 'dot 4esp' which is 'socially designed' for cats with traction control and stability control
I think it's all just marketing fluff
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Fitted Engine Guard to my P38A oil burner. Bolted the temperature sensor to the head. It takes a lot longer than the coolant needle to reach a steady temperature but seems to sit between 80C and 90C, admittedly on the inlet side. Maybe I should have put it the exhaust side, although I am guessing it will heat up PDQ should the coolant go missing.
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
You get plenty of beeps and warnings before the becm shuts the engine down from overheat. Admittedly by time it shuts down Itl already be too hot for the head but you do get warnings before that
Is All Brake Fluid Synthetic? Debunking Myths And Unveiling The Truths
Discover the truth about brake fluid composition in cars with a deep dive into synthetic vs. natural options like DOT 3, 4, 5, and 5.1. Unravel the benefits of synthetic brake fluids for consistent performance, thermal stability, and moisture resistance. Debunk myths around compatibility and...
www.carfluidguide.com
I would add that it's best to use one or the other, don't use 'synthetic' as a top-up to standard DOT4.
Scotiawhiskers
Well-Known Member
- Posts
- 877
- Location
- Manchester
Grimsby to home via the overnight stop. 150 faultless miles of comfortable wafting, 47mph average with 22.7mpg according to the trip computer. Very relaxing journey.
brianp38dse
Well-Known Member
- Posts
- 20,062
- Location
- heathrow
Well the mot did not go well top and bottom ball joints on front axle and a rear wheel bearing so the motor will get sorned and I will fix it when I get time I have had a set of lemforder joints sat in the boot for three years but didn't know they needed changing
I got them after I did the rebuild on all the bushes or I would have done them at the same time,, never mind
I got them after I did the rebuild on all the bushes or I would have done them at the same time,, never mind
Henry_b
Think outside, no box required.
- Posts
- 15,506
- Location
- somewhere else
Fitted 2nd hand abs pump, which fixed the intermittant ABS fault, my reward?
EAS fault....
EAS fault....
Probably not a popular opinion - my L322 was written off due to a minor collision (other driver at fault), so I took the payout, added a bit to it and bought a L405 4.4 TDV8. Brought it up to a decent standard, realised my usage wasn't compatible with an EU5+ diesel, so bought an EU6 L405 petrol.
Couldn't be happier - no long list of things to do, I just drive it. Sure I've had to do 'a bit' to bring it up to standard, all fluids & filters, spark plugs and at some point replace the wheels & tyres.
It does however, give me the weekends back, no more messing around and pre-planning the ever-extending list of things I have to do / things I need to do.
Oh, and it's a very comfy, enjoyable place to be - despite all the electrics / electronics which refuse to fail, despite the internet's best warnings.
Couldn't be happier - no long list of things to do, I just drive it. Sure I've had to do 'a bit' to bring it up to standard, all fluids & filters, spark plugs and at some point replace the wheels & tyres.
It does however, give me the weekends back, no more messing around and pre-planning the ever-extending list of things I have to do / things I need to do.
Oh, and it's a very comfy, enjoyable place to be - despite all the electrics / electronics which refuse to fail, despite the internet's best warnings.
- Posts
- 33,600
- Location
- North Shropshire
Now you've done it! The winker fluid will leak into the cabin and make the headlining sag, causing the boot to fill with water
On a serious note that's half the reason i ditched the p38.. the list kept getting longer to the point i couldn't rely on it as a daily
- Posts
- 12,628
- Location
- Sud ouest France !
Stomped backwards and forwards to Royan here in France over two days. A night out at Royan. Can't fault my old bus.
Sorting
out the dark roads as well... Watch this space. 
Sorting
- Posts
- 33,600
- Location
- North Shropshire
The other main reason, as much as i loved the car when it was having a good day, I'd just fallen out of favour with itNow you've done it! The winker fluid will leak into the cabin and make the headlining sag, causing the boot to fill with water
On a serious note that's half the reason i ditched the p38.. the list kept getting longer to the point i couldn't rely on it as a daily
Datatek
Well-Known Member
- Posts
- 44,883
- Location
- Near Poitiers SW France
P38, frequent niggles but generally reliable, simple electronics, cheap and easy to repair unlike the L322.
My lad has a pair similar onStomped backwards and forwards to Royan here in France over two days. A night out at Royan. Can't fault my old bus.
SortingView attachment 328950 out the dark roads as well... Watch this space.
- Posts
- 33,600
- Location
- North Shropshire
you're right, generally more straight forward, certainly on the mechanicals, but even the 'simple' <abc> module is beyond my 'rusty' GCSE electronics capability, pun intended. the p38 is at the age where even the reliable electronicals are starting to fail either thru use or old age - you can't simply swap with a good used part because it will likely be in a same/similar state, so unless you can mess about with circuit boards and all the associated twiddly bits, its not cheap and easy to repair. I appreciate your skills far surpass mine
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
See i can't say either of my l322s have been overly expensive to repair, or that troublesome even with my if i have to take this apart i may aswell do 3 other things while im there,
There has been a few unexpected bits or pricey bits but i have worked them harder then they've probably ever had in their life
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
On a side note has anyone towed high loads with an l322, iv bought 3 transits over the weekend 3 lwb high tobs not jumbo sized, 2 are quite local no real worries there the one iv bought the one I really want and want to keep for myself is in High Wycombe but the gearbox is howling and probably won't make the 580mile drive home its sitting as an idea just to rent a brian james tri axle and just set off down for it, spend a few days at my pals and head back with it, im not shy too throwing heavy loads on my RR but high sided is it worth the hassle or is it going to be one of them i should just pay a lorry to pick it up?
