RangeRoller dt
Well-Sprung Member
- Posts
- 14,396
- Location
- Trapped inside my head @ LZ asylum
I seem to remember somebody losing a nanocom. Fortunately all members I’ve had dealings with have been outstanding people of moral character.
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,620
- Location
- North Shropshire
Has the windows down today and heard a clink clink at full lock.. approx every wheel revolution.Be careful how you say that.
First it’s CV type joints on the front and back, with a conventional UJ in the middle of the rear near the bearing I think.
When 1 of the front 1s went it was a clicking not a whine.
Oh and it’s not a simple 30min drop the prop job.
J
Yes i checked nothing was catching
Not good. I've got a trackday on Friday too so need to tow!!!
- Posts
- 345
- Location
- Maidstone, Kent
Make wider turns?
- Posts
- 33,620
- Location
- North Shropshire
with the radio turned up!Make wider turns?
dubbleRR
Well-Known Member
- Posts
- 1,018
- Location
- highlands of Scotland
Today ,well a couple of days ago i freed off a rear brake that was binding a bit /lack of use the wife says /any way iv noticed the mpg was getting poor 24 ish use to be 27 ,to 30,as it turns out after servicing all four 3 were sticking a bit ,went out today n its a flying machine ...So if you getting poor mpg check the brakes ,i dint even have any real signs they were sticking just a little bit o heat from one rear ,thats what i did this week , 
I also rotated the wheels,,......
I also rotated the wheels,,......
- Posts
- 33,620
- Location
- North Shropshire
Been a while mine did!Mine do this automatically every time i go for a drive
Well, I almost managed to remove the old exhaust today. Well, time to pull out the angle grinder next week-end.
fucmeitsandy
Well-Known Member
- Posts
- 161
- Location
- louth
Got mine running after blowing apart one of the oil cooler pipes and spraying all my dirty oil all over everything .
Fingers crossed it's not damaged any thing !!
I've just looped a bit of pipe bypassing the oil cooler and filled her up with oil , to see what's what .
Do I even need a oil cooler ??
Fingers crossed it's not damaged any thing !!
I've just looped a bit of pipe bypassing the oil cooler and filled her up with oil , to see what's what .
Do I even need a oil cooler ??
I have one, and I love it, especially after being in the desert. While I never sprayed oil all over the place you did, I did when changing the oil... Took almost a year for the stains to fade away on the pavement on the drive way...
Datatek
Well-Known Member
- Posts
- 44,909
- Location
- Near Poitiers SW France
I doubt a cooler would have been fitted if it's not needed, I assume it's the engine oil cooler?
Could be PS or transmission oil cooler, engine oil coolers are generally oil/coolant not oil/air as an aid to getting the engine and heater up to temperature quickly.
Depending upon which system it's on, that 'bit of pipe' might not be secured well enough (or rated at high enough pressure) to last very long.
Depending upon which system it's on, that 'bit of pipe' might not be secured well enough (or rated at high enough pressure) to last very long.
fucmeitsandy
Well-Known Member
- Posts
- 161
- Location
- louth
The bit of pipe was only a temporary fix , to see if it would run . It did so now I'll swap that bit of pipe for a bit of hydraulic hose , double jubilee clipped on .
Then I'll run it like that to see if any nasty knocks , rattles or bangs happen . Then , if it's all good a permanent fix will happen !
Then I'll run it like that to see if any nasty knocks , rattles or bangs happen . Then , if it's all good a permanent fix will happen !
- Posts
- 4,655
- Location
- Rotherham
Because my old belt tensioner had seized, this was found out when FIP replaced last week , the belt had stretched thus causing the replacement tensioner to jump to slack position every time the engine was stopped so new belt fitted today and all is good
RangeRoller dt
Well-Sprung Member
- Posts
- 14,396
- Location
- Trapped inside my head @ LZ asylum
Datatek
Well-Known Member
- Posts
- 44,909
- Location
- Near Poitiers SW France
Took the family into town today, strong smell of diesel on the way back. Number 4 injector leak off pipe split at the nipple, great German engineering, they seem to last for ever on my Transit.
Having recently changed employers to one that doesn't insist on working Saturdays, we took a very pleasant 250mile round trip to Yorkshire to buy some pies from Stanforths, then went to Malham Tarn to eat the warm ones! (we left a few bits of crust in memory of Ruby our GSD, it was her absolute favourite place!) as a bonus, the DPF is now empty and the gearbox has settled down to altogether smoother changes.
