- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
There's not a lot of room. Don't think you'd get tge mount part out. Odd for the lever to fail. Sure the lever is stuffed?
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
There's not a lot of room. Don't think you'd get tge mount part out. Odd for the lever to fail. Sure the lever is stuffed?
Tenebreaux
Well-Known Member
- Posts
- 4,362
- Location
- Armagh
Yeah, the button is shagged, it won't ratchet.
I suppose I could take the gaiter off and see if a good clean and some lube sorts it.
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
He said the handbrake?
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
Could try electrical contact cleaner vor brake cleaner. Then maybe some graphite lube down there.
kds
Well-Known Member
- Posts
- 2,273
- Location
- old,ugly, tired in Lincoln.
The button swells up over time so when its pressed in it wont pop out, you sure its not just that ?
Tenebreaux
Well-Known Member
- Posts
- 4,362
- Location
- Armagh
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
Console out isn't long. Only a few nuts and screws.
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
Tenebreaux
Well-Known Member
- Posts
- 4,362
- Location
- Armagh
Thanks fellas. I guess I know what I'm doing Saturday morning.
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
Quick enough to check if it is leaking: put her on high, axle stand under chassis rail and tailgate up, reach under and feel bottom of handbrake drum with a finger. Should be dry.
Henry_b
Think outside, no box required.
- Posts
- 15,523
- Location
- somewhere else
My Rear output seal is leaking..
As is the front output seal on the gearbox
The Morse chain is chattering to.
Needs a rebuild.
Don't fancy doing the job on the drive.
Hard enough lifting one up while the cars on a ramp!!
As is the front output seal on the gearbox
The Morse chain is chattering to.
Needs a rebuild.
Don't fancy doing the job on the drive.
Hard enough lifting one up while the cars on a ramp!!
- Posts
- 19,323
- Location
- Buckinghamshire, UK. ('95 DT)
My Rear output seal is leaking..
As is the front output seal on the gearbox
The Morse chain is chattering to.
Needs a rebuild.
Don't fancy doing the job on the drive.
Hard enough lifting one up while the cars on a ramp!!
Getting the transfer box off is relatively easy. Bit awkward on your back. Getting it back in was trickier. Fortunately a few mates dropped by so we held it balanced on the trolley jack and pushed ot back on.
Henry_b
Think outside, no box required.
- Posts
- 15,523
- Location
- somewhere else
Pfft lucky you i had to hoist if off the floor and balance it with one hand while putting bolts in with the other!
Mecs don't need the gym lol
brianp38dse
Well-Known Member
- Posts
- 20,113
- Location
- heathrow
You need a motor cycle lift its much easier, just stick a bit of worktop on top, and a couple of bricks under the higher part of the tf box and jobs a gooden
RangeRoller dt
Well-Sprung Member
- Posts
- 14,415
- Location
- Trapped inside my head @ LZ asylum
Gave it good clean inside and out. Been on a course for few weeks, in the mud, was stinking from me and the dog. Always comes up a treat though
Started smoking a bit when cold lately. Quite considerable for first few minutes and will soot if you rev it. Time for new plugs me thinks
Started smoking a bit when cold lately. Quite considerable for first few minutes and will soot if you rev it. Time for new plugs me thinks
Most likely oil change and air filter will help, if its glow plugs they dont start very easily
