Littelwill
Well-Known Member
- Posts
- 3,065
- Location
- Lincolnshire
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Littelwill
Well-Known Member
- Posts
- 3,065
- Location
- Lincolnshire
Bought some new bits for it.... Again...
ovalandrover
Well-Known Member
- Posts
- 1,610
Packed all the gear in and some spares to go to Iceland and then on to Russia as i leave on the 8pm ferry to Dunkerque tonight.
Littelwill
Well-Known Member
- Posts
- 3,065
- Location
- Lincolnshire
A few last bits for the suspension overhaul!!
- Posts
- 58,170
- Location
- Preston Lancs.
brianp38dse
Well-Known Member
- Posts
- 20,065
- Location
- heathrow
Jeeezzzz do they acually have a driveing test overthere .
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
I think it is the vodka that is the problem.
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
starter motor starts being a dick. And passanger door has stoped iluninating the interior lights. Been in it all day since 8am just home. Clocked a few miles. Cant even be assed taking ladders off tonight.
StuckAgainSteve
Well-Known Member
- Posts
- 2,276
- Location
- London
Relegated the old girl to weekend plaything. Just starting to get too tired as a daily driver.
SpanishTony
Active Member
- Posts
- 297
- Location
- Cheshire
But what are you doing with the car?
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Slow 35mph? Hope you had diagnostics with you
Slow 35mph? Hope you had diagnostics with you
Thankfully not - just the 'EAS FAult' with christmas tree lights and the ride height indicator on the dash.
Nanocom lives in the glovebox these days but I carried on as it wasn't deflating any. I'll go out and check the error code(s) in a wee bit!
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Pressure signal constantly high would be my bet
Pressure signal constantly high would be my bet
I'd agree with you... solution?
In fact, gonna go out now and find out!
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Driver pack, I can give you a possible fix. Also worth checking all connector pins in the EAS box.
Almost correct...
"Pressure switch is not changing state, always off"
This is a replacement driver pack, came with the replacement valve block I put on a few weeks back..So I have two for testing I guess? Pressure switch is also brand new in this block too.
"Pressure switch is not changing state, always off"
This is a replacement driver pack, came with the replacement valve block I put on a few weeks back..So I have two for testing I guess? Pressure switch is also brand new in this block too.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
That is the Nanocom version of pressure signal constantly high as reported by the free EAS software. Likely cause is a duff electrolytic in the driver pack, I've done 2 and the fault has not recurred so far.
I can tell you how to do the fix or I can fix it for you for the cost of return postage
