- Posts
- 12,628
- Location
- Sud ouest France !
My gut says no... I'll drop the valve unit entirely next Sunday and go through it all. I've got enough info together to go through it thoroughly. Just a tad worried as it is a mega job.
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
I have the complete ZF workshop manual I think (if XP has not swallowed it) I can try to send it to you if it would help.My gut says no... I'll drop the valve unit entirely next Sunday and go through it all. I've got enough info together to go through it thoroughly. Just a tad worried as it is a mega job.
Sounds like time to get the box out of the scrapper.
Bonne chance
- Posts
- 12,628
- Location
- Sud ouest France !
I'd appreciate that Keith, thank you. If could get a full rebuild kit without being ripped for taxes and a sprag clutch I'd rebuild.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
Not sure why you wouldn't use the scrapper?
Henry_b
Think outside, no box required.
- Posts
- 15,506
- Location
- somewhere else
Worth swapping the valvebody off of your other trans to see if there is any change, it sounds to me like a Governor valve or Solenoid issue.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
Can't find the manual on my replacement computer, I'll have to go looking on the old XP tomorrow, just hope it's not another one of the files it's eaten.
I may have a back up on my tablet. Got to go cook dinner now.
- Posts
- 12,628
- Location
- Sud ouest France !
Bon appétit Keith and thanks.
- Posts
- 12,628
- Location
- Sud ouest France !
It's been stood for over ten years and someone at some point has damaged the output shaft to the convertor....
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
You can swap the front section with the pump.
- Posts
- 12,628
- Location
- Sud ouest France !
I'm not kean on the idea that the clutch packs haven't turned in over ten year or so...
- Posts
- 12,628
- Location
- Sud ouest France !
I'll drop the block and go through it, then if I find nothing untoward I may do just that.
- Posts
- 33,600
- Location
- North Shropshire
Not had time to change the reluctor ring yet but put the new sensor in so I'd have half a chance on the snow. At least the lights went out! Hoping to get chance to do the ring next week.. along with the ball joints busy busy
busy busy
Scotiawhiskers
Well-Known Member
- Posts
- 877
- Location
- Manchester
Buttons are there, but appear to do nothing. Otto is only a 4.0 SE so I assumed it was a 'disabled for plebs' feature that could be turned on with the right software / hardware interface.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
All I had to do was fit the stalk to get mpg, range, average speed and trip 2
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
ZF is German, you should be able to get the parts from Germany cheaper than from France.
- Posts
- 12,628
- Location
- Sud ouest France !
Good point Keith.
- Posts
- 33,600
- Location
- North Shropshire
Upper tail gate is getting hard to shut.. needs a real slam.. is there any adjustments, or does it just need lubing up?
- Posts
- 12,628
- Location
- Sud ouest France !
A blast with some spray grease maybe? I'm not sure there's any adjustment on the top section
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
3 in 1 spray, it was just the mechanism stiffening up on mine.
- Posts
- 4,653
- Location
- Rotherham
Fecking Nissan Juke drivers. Just run the good lady up to her dads as the roads are quite treacherous with frozen snow and ice. Idiotic Juke driver just pulled out in front of me and another car nearly causing a crash. Fortunately he was the one who went side ways into a side street. Many expletives were thrown his way and pillock replied but I'm in a 4x4 and should be OK.. My missis ever the wit explained NO we are in a 4x4 and we drive to the conditions not like the ***** you are
