- Posts
- 9,105
- Location
- Roaming the UK on assignments
Those fuse and relay boxes look familiar, I got two of them for my headlight relays, air horns, diesel fuel filter heater etc, very good bits of kit 
TD5 90 Project
- Thread starter KISSMYAURA
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
New voltmeter and temp gauge.
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
More test fitting for centre tray electrical distribution, conduit and master feeds. As the location from underside is high risk form water ingress will ptfe and silicone seal conduit glands for main battery box and centre tray.
Still more to do before final cable route, want to use the cub fuse / relay box to house relays and timers for :
Still more to do before final cable route, want to use the cub fuse / relay box to house relays and timers for :
- Heated Screen & Mirrors
- Heated Seats
- Front light bars / spots
- LED Load space lights / Side and rear flood-pool lights / Engine bay inspection lights
Last edited:
bankz5152
Well-Known Member
- Posts
- 9,300
- Location
- South London/North Kent
Much neater than mine! Nice job!
- Posts
- 9,105
- Location
- Roaming the UK on assignments
Perfect timing, I'm just planning my rear aux distribution set up, looking like a 35mmsq cable front to back and a distribution post to a fuseboard and then off to the accessories.
I'm not 100% on whether I should fit a relay board too?
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
you might as well, depending on how many accessories you can use than as your fuse board......
- Posts
- 9,105
- Location
- Roaming the UK on assignments
So far I'm looking at :-
1) on board air compressor system
2) aux hot air diesel heater for the cabin on cold drives/camping
3) stereo amp for better sound quality when I turn up the choones
I was thinking 35mm as it gives a massive reserve of power supply should I also fit rear andersons connectors for jumper cables?
Thoughts & comments appreciated.
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
i fitted anderson connector under passenger seat, ideally should in an access box outside (trap door side entry)So far I'm looking at :-
1) on board air compressor system
2) aux hot air diesel heater for the cabin on cold drives/camping
3) stereo amp for better sound quality when I turn up the choones
I was thinking 35mm as it gives a massive reserve of power supply should I also fit rear andersons connectors for jumper cables?
Thoughts & comments appreciated.
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
Lost my best friend yesterday, Luna 13.5 years, she was in my arms looking into my eyes as the vet did what he had to do.
I am ****ing broken.
I am ****ing broken.
1988smithy
Well-Known Member
- Posts
- 4,042
- Location
- West midlands
Sorry to hear that mate
Turboman
Mab An Gov
- Posts
- 60,151
- Location
- Lathrowda, Kernow
DevonGuy
Well-Known Member
- Posts
- 3,124
- Location
- North Devon
The most heart breaking event I know, having lost so many over the years. I feel your pain and hope it will in time be supplanted by the many happy memories of your time with Luna.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
My heart felt condolences
It brings back bitter memories of letting go of our Border Collie a couple of years ago
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
Middle Seat Under Tray Paint update:
View attachment 173483
- Upol Etch primer
- Epsom Green / Lacquer (Halfrauds)
- Stone Chip & Matt Black (ECP optima)
Last edited:
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
Aftermarket Anodised Ali Fuel cap cover. I like it....
Last edited:
KISSMYAURA
Well-Known Member
- Posts
- 2,799
- Location
- KENT
New Rear ARB, BJ and Bushes fitted today, feels a bit better on corners less body roll etc.
