spring compressors?

Litch · Dec 6, 2010

Unless fitting a massive lift I can't see the need for spring-compressors, I have certainly never needed them with standard & HD springs.
Jack-up & support the chassis, remove the wheel, lower the axle on a jack (watch those brake-lines), remove the shock and the spring will just pull out.

Easy job.

bodhi-z · Dec 6, 2010

thanks Litch, thats all I needed to know!
Much appreciated.

hughesy · Dec 6, 2010

Spring compressors are totally unnecessary for changing land rover springs.

bustersbus · Dec 6, 2010

As said before about not needin' spring compressors and jackin' up and supporting the chassis etc

Here's some photies fur ye...

piece o' **** really

Dont forget to have a couple o' new turret rings as there's every chance ye'll break thum tryin' to get thum off!

The rear ones are even easier... and ye don't need new rings fur them. Might be an idea to check the condition of the spring seats on the axles as well

landy90will · Dec 6, 2010

dont need them, you can manage without.

bodhi-z · Dec 6, 2010

thanks very much for the pictures Buster, much appreciated!
All looks simple enough...though I shouldn't tempt fate I guess!
Will definitely replace turrets and seats etc whilst it's all apart...
Cheers.

bustersbus · Dec 6, 2010

bodhi-z said:
thanks very much for the pictures Buster, much appreciated!
All looks simple enough...though I shouldn't tempt fate I guess!
Will definitely replace turrets and seats etc whilst it's all apart...
Cheers.

Nae wurries

It really is quite simple (apart from the hassle of shifting stuff to get at the top of the shocks). The only probs ye might have is removing the top nuts on the front shocks and possibly the bottom nuts on the rears. Give them a guid soakin' in GT85 / wd40 etc and leave for a wee while.
If ye look at the ends pokin' out past the nuts, ye should see a couple of wee flat bits, try stickin' a set of adjustables or summit on these to hold the shocks while takin' the nuts off...

Failing that, cut or split the nuts off.

Another thing to remember is, when takin' the washers / bushes etc off is place them out the way they came off....

MrJC · Dec 7, 2010

For Sale.... one pair of spring compressers, used once.... but worked a treat

Litch · Dec 7, 2010

Photos are text-book, that is exactly as I do it and there are no problems whatsoever.

If you can't stop the front shocks turning due to corrosion of the bottom thread then there is a quick & easy way to remove them but is usually damages the shock however this won't be a problem if you are changing them for new.
Extend the spring, fit a ring-spanner to the bottom nut and then use a pair of Stilsons through the extended spring to turn the shock body, very easy and 100% success with no faffing around. If wanting to keep the shock and the threads are corroded, good luck!!!

spring compressors?

Litch

Well-Known Member

bodhi-z

Member

hughesy

Well-Known Member

bustersbus

Well-Known Member

landy90will

Member

bodhi-z

Member

bustersbus

Well-Known Member

MrJC

Well-Known Member

Litch

Well-Known Member

Similar threads