alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
ok well i have access to stuff needed to measure the bores. do the pistons need to come out still. there is a lip at the top of the bore but its very small.
paddocks and piston rings
- Thread starter alex8882
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
made a start on rebuilding the head today, but had to have the valve seats recut as they were in a poor state. also had the valve guides clean, all relapped and new seals and gaskets fitted. D day tomorrow as the bores are going to be inspected and measured
GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
Good luck Alex
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
cheers pal, the injectors are getting tested also see what the crack off pressure is. old chap at the road re cut the seats,cleaned the guides air lapped the valves and testing the injectors all for £20
GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
That's a bargain price. You sure lucked out there.
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
tell me about it lol. got pictures to follow later
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
the big end bearings were shot down to the copper lol. going to have to check the mains now aswell. pistons are cleaned up and ready for the new rings once they arrive, injectors all checked out ok also.
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
Well all back togther and running lovely. Will upload pictures either today or tomorrow when i can get my phone to conect to my pc. Strangley there is still pressure at the air filter on tick over, raise the revs even only 100rpms and its gone. head was pressure tested and came back fine,all valves were sealing well so i'm alittle stuck as to where to look next. Bleeding the coolant system was a pain a friend of mine used a vacum bleed in the end, two seconds and all the air was out
GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
Nice one mate, I'm glad you're back on the road.
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
cheers pal me to. just needs to sort out the inside now. new seats and door cards, then to replace the cv's and halfshaft, and upgrade to to hd drive flanges. then new wheels and tyres so next bill is £672 according to paddocks lol
Similar threads
