New nuts for attaching rear propshaft to handbrake drum?
- Thread starter Peep110
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 6,411
- Location
- North Perthshire
Assuming that the bolts are genuine then:
https://www.island-4x4.co.uk/propshaft-nuts-38unf-britpart-nz606041lx10-p-34664.html
https://www.island-4x4.co.uk/propshaft-nuts-38unf-britpart-nz606041lx10-p-34664.html
Safetyspice
Member
- Posts
- 31
- Location
- Wiltshire
I am just in the process of replacing mine and they were also mashed and spinning in the bell housing, I ordered a set of 4 from
https://www.jgs4x4.co.uk/defender-rear-propshaft-nut-and-bolt-kit/
Does any one know what the torque setting is for the 30mm rear drive flange nut on the back of the transfer box is, cant find any reference to it in the WSM?
https://www.jgs4x4.co.uk/defender-rear-propshaft-nut-and-bolt-kit/
Does any one know what the torque setting is for the 30mm rear drive flange nut on the back of the transfer box is, cant find any reference to it in the WSM?
Safetyspice
Member
- Posts
- 31
- Location
- Wiltshire
Nice One, thanks
Ah ok so 3/8 UNF, yes, sorry, I've just found a full kit for this too here: https://www.jgs4x4.co.uk/defender-rear-propshaft-nut-and-bolt-kit/
- Posts
- 4,630
I would recommend getting the box of nuts rather than just the kit. The nuts should be replaced every time they are removed but the bolts last a lot longer.
https://www.paddockspares.com/propshaft-nut-x-100.html
Alos remeber that they are a 9/16 spanner not a 14mm as I have seen lots of people do. A 14mm with nicely round them off and is probably the reason they are in their current state.
https://www.paddockspares.com/propshaft-nut-x-100.html
Alos remeber that they are a 9/16 spanner not a 14mm as I have seen lots of people do. A 14mm with nicely round them off and is probably the reason they are in their current state.
