MOT emissions fail

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
LeadFarmer

LeadFarmer

Well-Known Member
Posts
6,742
Location
Yorkshure
My 1996 110 300tdi has just failed its MOT due to emissions.

It's hardly had any use in the last few months and maybe this is the reason, perhaps it needs a good blast before getting it tested again? It does kick out a bit of black make on start up and under heavy acceleration.

Many years ago i did have the fuel pump tweaked to stop it being so sluggish, but its never failed previously.

Are there any injector cleaners I can squirt into the fuel tank that might help?
Could it be the injector pump?
 
You do need to blast it out. 2nd gear and drive it up to speed at high revs on the way to mot centre is how I do it. If still a problem, adjust throttle cable so it cannot rev so hard and put it back after test.
 
A few people on here have had good results with fuel additive too - I use Millers ECOMax. It mostly sounds like it needs a good blast to get it really warm and blow out all the crap.
 
I shall rebook the test and give it a blast, and add some Millers ECOMax.

Is this the stuff you use?

diesel_power_ecomax-170x300.jpg
 
Last edited:
I use a double dose of wynns injector cleaner in half a tank of diesel and give it 30min of Italian tune up before the mot. has not failed yet. But as said above it is most likely due to lack of use, diesels like to be worked rather than cosseted along. Find a long section of steep hill, hook up 3.5 ton of trailer and go up the hill a dozen time with your foot to the floor. Should soon burn off anything and clean up the exhaust.
 
zeaphod said:
That's the stuff. It ups the octane rating of the fuel you add it to - you might notice a slight increase in power.
Click to expand...

Diesel doesn’t have Octane, but it does have Cetane. ;)


LeadFarmer said:
I shall rebook the test and give it a blast, and add some Millers ECOMax.

Is this the stuff you use?

diesel_power_ecomax-170x300.jpg
Click to expand...

I have used that stuff for a few years. I usually give it a double shot, then fill the tank right up. I have noticed the EGT’s are lower on a tank with this in as apposed to a tank without it. Not very scientific, as I didn’t record outside air temp and the likes, but around 40deg lower on dual carriageway speeds.
 
Brill, I’ve just bought some Millers Ecomax

Haven't got it in my hand as I type, but I think it’s a 50ml dose to 50L of fuel. I’m almost on an empty tank of fuel, would there be an advantage to squirting a half measure in now, as a concentrated dose, using up the fuel that’s in the tank and then filling as per the instructions?
 
Last edited:
LeadFarmer said:
Brill, I’ve just bought some Millers Ecomax

Havengit got it in my hand as I type, but I think it’s a 50ml dose to 50L of fuel. I’m almost on an empty tank of fuel, would there be an advantage to squirting a half measure in now, as a concentrated dose, using up the fuel that’s in the tank and then filling as per the instructions?
Click to expand...
I would suggest not as it is it looks to be a performance/economy additive. If it was a focused fuel system/injector cleaner then there would have been an advantage to a more concentrated does. But I have not used it so am happy to be corrected.
 
LeadFarmer said:
Would using premium/ultimate diesel help with the MOT?
Click to expand...
It allegedly has more detergent in it. However, anything strong enough to clean injectors etc would surely also wreak havoc with seals etc? I don't know
If it worked, why are people in the business of injector cleaning?
Just my speculation
 
for the last 5 years mine has passed missions with no trouble then last year barely scrapped through,, which i put down to a lack of use as only doing local trips and only 1000 miles.
this year i put a bottle of the fuel cleaner in the tank a month before the test then on the morning gave it a good 20 min blast up the a23 then straight in for mot. and it barely had a score on the reading .. like it used to,, so i would say defiantly give it dose of fuel injector cleaner and give it a good blast ,, i always fill the replacement fuel filter with injector cleaner when i service it as well. think it had a reading .075.. last year was 1.2 i think and the pass is below 1.5 i believe

one year i filled up with one of BP special clean diesel fuels and in the morning it had cleaned the tank so well i lost half the tank of fuel
from a rust hole that opened up in the seam of the tank so i never used that again..

i just use the injector cleaner sold in wilkinsons. redexx i think it is ,, buy it when its on offer useually 2 quid a bottle then.. so nothing fancy
 
LeadFarmer said:
The MOT certificate says 'Emissions not tested', but that because as soon as they started testing it, it went off the record, maxed out their sensor.
Click to expand...



... wow .. ive never heard of that before .. was it smoking heavily as well then. .
would have thought it would still have given some sort of a reading..
maybe if anyone on here that does mots, might be able to comment more on this as its not something ive heard of.
 
I take it you dropped it off warm and they tested the emissions straight away......

Mine recently passed and wouldn't be surprised if my tester pulled the hose of the back of the air filter to let it breath a little easier (we get on well).
 
You must log in or register to reply here.

Similar threads

T
Emissions
Replies
7
Views
1K
TR3a
T
J
Excessive smoke MoT failure
2
Replies
28
Views
3K
Rangieman123
Rangieman123
J
engine cuts out at high revs, eml on td5
Replies
2
Views
342
Tim4x4
Tim4x4
hbhughes
Injector pump gone bang :(
Replies
10
Views
1K
hbhughes
hbhughes
M
110 Station Wagon unladen weight and MOT class
Replies
5
Views
415
moth
M
Back
Top