mini bus seats in the 90

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

superdougie

Active Member
Posts
117
Location
leeds West Yorkshire
Next project underway, it seems pretty straightforward is there anything I should keep an eye out for? I'm removing the legs of the seats and bolting them to the arches with some 8mm plate behind.....The seats are bloody heavy
 
looks lethal ill be honest -

plating from the back is only half the issue - ther is push through forces from the top surface as well as pull through from the rear in a crash. I would not like to defend from the owner/drivers position in court after a crash.
 
did the same with my 90
work so well and cheep.:cool:
 

Attachments

  • rear seat defender 004.JPG
    rear seat defender 004.JPG
    72 KB · Views: 210
  • rear seat defender 005.JPG
    rear seat defender 005.JPG
    44.8 KB · Views: 205
  • rear seat defender 006.JPG
    rear seat defender 006.JPG
    45 KB · Views: 203
true - regardeless of how big a plate you bolt it too ... its still only held to the rest of the body by a few spot welds and some 4.8mm blind rivets.

post crash i suspect it would look like a sardine can been torn open.
 
top drive said:
true - regardeless of how big a plate you bolt it too ... its still only held to the rest of the body by a few spot welds and some 4.8mm blind rivets.

post crash i suspect it would look like a sardine can been torn open.
Click to expand...

maybe herring in a tomato based mediterranean sauce
 
Are they Rescroft seats? I spoke to the tech guys there when researching seats for my Defender 90, i went for the Defender III (name just a coincidence) and they said in a crash the front feet push down and the rear pull up and to put a 4 inch x 4 inch plate between seat foot and tub floor on the each front legs and same on rear but from under the floor, i over killed it by putting a complete steel plate on the whole floor in between seats and floor and another plate under the rear feet about 5 inches wide going under both seats rear legs. OK added weight but it won't budge now. They don't hinge and are static but i wanted them safe for the kids.
 
They are part of the seat, built in, as they are on a coach, they are coach seats. Probably safer than the ones land rover do, and they don't connect to the chassis??
 
"They are part of the seat, built in, as they are on a coach, they are coach seats. Probably safer than the ones land rover do, and they don't connect to the chassis??"

Yes they do. And in a bus you can have the seat belts attached to the seat structure, if the seat structure is bolted to the vehicles structure(chassis) or rails bolted to the vehicles structure(chassis)

And the angle of the shoulder straps on the front seats will compress your spine in a frontal impact.
 
You must log in or register to reply here.

Similar threads

jimllshiftit
Any advice for novice welder about to stitch new rear cross member to 90 chassis?
Replies
3
Views
921
tottot
tottot
K
What money should I be asking?
2
Replies
27
Views
4K
Karls
K
alexmcrobbie
Defender 90 2010 Defender 90 Hard Top for sale
Replies
5
Views
3K
alexmcrobbie
alexmcrobbie
S
1988 90 replacing lights with LEDs and have lots of questions
Replies
5
Views
943
sleepybear
S
SPLRover
Brakes & Suspension & Wiring Recommendations - 1988 90 Restoration
2
Replies
36
Views
3K
Chalky.
Chalky.
Back
Top