SteveJones
Member
- Posts
- 70
- Location
- Berkshire, UK
Guys,
Just spent a few hours replacing the rear UJ (where prop shaft connects to rear diff), all went ok except that I noticed a small amount of lateral movement in the joint when assembled. I fitted it and gave it a short test drive and sure enough the joint is slipping up and down on the pivots, anything above 20 mph and the vibration kicks in, at very slow speed I can hear the prop shaft 'dropping' every quarter turn. I guess the crossmember bit of the UJ is too short or the cups are two short, unless I'm missing the point? I gave the chassis number to the supplier and they checked the part number I needed, I guess it's wrong but before I call them tomorrow is there anything I should check first? Defender 90, 1987.
Cheers!
Just spent a few hours replacing the rear UJ (where prop shaft connects to rear diff), all went ok except that I noticed a small amount of lateral movement in the joint when assembled. I fitted it and gave it a short test drive and sure enough the joint is slipping up and down on the pivots, anything above 20 mph and the vibration kicks in, at very slow speed I can hear the prop shaft 'dropping' every quarter turn. I guess the crossmember bit of the UJ is too short or the cups are two short, unless I'm missing the point? I gave the chassis number to the supplier and they checked the part number I needed, I guess it's wrong but before I call them tomorrow is there anything I should check first? Defender 90, 1987.
Cheers!