L322 ignition key problems

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
badfluffy

badfluffy

Well-Known Member
Posts
2,132
Location
northampton
So business partner take his l322 td6 to mot station, locks car gives them the key, some time later get a call saying key don't work, of down to garage with spare key and neither will turn in ignition i know @goldrover had same problem but anyone have any ideas
 
badfluffy said:
So business partner take his l322 td6 to mot station, locks car gives them the key, some time later get a call saying key don't work, of down to garage with spare key and neither will turn in ignition i know @goldrover had same problem but anyone have any ideas
Click to expand...
I think there's a solinoid that gives problems with the ignition/steering column. Try a search.
 
Hello folks, I think this thread of mine will help shed some light on the subject. Half way through you’ll find it starts again and then again for Goldrover.

https://www.landyzone.co.uk/land-ro...-2005-4-2-supercharged-will-not-start.312101/

Essentially, bad earth (engine to chassis) plus others - water ingress behind the fuse box, in the cabin and in the boot - low battery volts or dead cells.

All or any of the above can and will cause the symptom being described here. In my case i had to disconnect the battery every night for several weeks before the electrical circuits got their s..t together.

It’s as though the bad earth throws all the coms out of sync with error codes displayed at will. Stay calm be methodical and make sure you have over 13 volts, clean earth point connections and no moisture in the glove box or boot.

Keep us posted on your progress. Tricky :)
 
Yes that’s part of the problem as the electrics control the release of the key to rotate in the barrel. I had exactly the same symptom as well as all the dash lights and non-starting. The fault codes would change every time they were reset, nothing made sense even to LR trained technicians with all the software and testing procedures. It was as if every module had stopped communicating in the correct sequence. I still have the new immobiliser they sold me but didn’t need.
Tricky :)
 
Tricky of York said:
Yes that’s part of the problem as the electrics control the release of the key to rotate in the barrel. I had exactly the same symptom as well as all the dash lights and non-starting. The fault codes would change every time they were reset, nothing made sense even to LR trained technicians with all the software and testing procedures. It was as if every module had stopped communicating in the correct sequence. I still have the new immobiliser they sold me but didn’t need.
Tricky :)
Click to expand...
My memory must be improving.:D:D
 
I too saw this solution on another forum at the time but was nervous about drilling into a component with a very hefty replacement cost if I got it wrong. I believe this to be a good solution in theory if you aren’t the one paying if it doesn’t go well (a stray piece of swarf). I can report that my method also worked and the fault never returned, without drilling anything. Let us know how it goes please.
Tricky :)
 
You must log in or register to reply here.

Similar threads

MrGorsky
P38A Occasional "Engine Disabled Press Remote" message on dash.
Replies
19
Views
1K
Datatek
Datatek
rich28uk
L322 Key programming
2
Replies
22
Views
4K
rich28uk
rich28uk
marjon
L322 Key fob case replacement.
Replies
5
Views
526
marjon
marjon
awkwardbob
L322 2003 L322 Can’t open bonnet -battery flat
Replies
16
Views
560
marjon
marjon
K
2005 L322 Transfer Failsafe (3 year problem, still unsolved).
Replies
8
Views
1K
Bemble
B
Back
Top