- Posts
- 9,095
- Location
- North Lincs
a grinder and paint make me the welder I ain't...that as a welder I make a very good plasterer and angle-grinder/flap-disk operator.
Still its better than I can do with tig!
I would just like to say
- Thread starter Hippo
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Still its better than I can do with tig!
- Posts
- 9,095
- Location
- North Lincs
Still looking for a vehicle, its getting boring now
- Posts
- 6,592
- Location
- uk
Similar here in Linkinshirshire. But its limited to 2 free disposals each of max 20kg, and limited to 2 per year. And you have to apply for a letter of permission in advance. Extra bags can be paid for at 20 sovs each. I roughly estimate I have got 150 - 200kg of the stuff. I will be talking to legit commercial peeps once it is all off the roof.Round here you get a special bag to put each sheet (or its remains) and they dispose of it for £16 ea.
- Posts
- 44,816
- Location
- East Dorset
...or Tom Tom I would imagine...eggspecting an amazon delivery today.. the van has gone past my house twice so far, now according to the app is over a mile away
dont they dont use a delivery route planner
- Posts
- 44,816
- Location
- East Dorset
- Posts
- 44,816
- Location
- East Dorset
Well.....
I thought I had nearly finished my tiling of the utility.
Only 3 and a 1/2 tiles to go, ...........
Looked in the box, ooops!
Only 2 whole tiles.
And there was me thinking I had loads spare.
Idiot that I am.
This is going under the boiler which will have a sort of cupboard around it, open top and bottom.
But it won't go down far enough to hide any make-do type work I will have to do.
Then I had a fink.
I'd only just put up the last 3 courses today and the bottom one the afternoon before.
So I had a bash at removing the bottom tile. With a bit of hammering on the handle of a thin scraper it came away.
Phew!
So I took another whole tile off and two halves, stuck the two halves into the spaces where the whole ones had been, the vertical edge lines up and each course is only 1/2 a tile short.
So it looks fine as each set of tiles doesn't have to come right up to the doorway in one case or the arch in the other as neither is of the same width. And I have now "won" the extra tile I need to finish it off.
Having a celebratory beer!!!
Enjoy your evening folks!
I thought I had nearly finished my tiling of the utility.
Only 3 and a 1/2 tiles to go, ...........
Looked in the box, ooops!
Only 2 whole tiles.
And there was me thinking I had loads spare.
Idiot that I am.
This is going under the boiler which will have a sort of cupboard around it, open top and bottom.
But it won't go down far enough to hide any make-do type work I will have to do.
Then I had a fink.
I'd only just put up the last 3 courses today and the bottom one the afternoon before.
So I had a bash at removing the bottom tile. With a bit of hammering on the handle of a thin scraper it came away.
Phew!
So I took another whole tile off and two halves, stuck the two halves into the spaces where the whole ones had been, the vertical edge lines up and each course is only 1/2 a tile short.
So it looks fine as each set of tiles doesn't have to come right up to the doorway in one case or the arch in the other as neither is of the same width. And I have now "won" the extra tile I need to finish it off.
Having a celebratory beer!!!
Enjoy your evening folks!
Hippo
Lord Hippo
- Posts
- 53,839
Not done a hole chuk yet. Watched butlersempire on youtoob do one. They dint bovva turning it over at arf time. Iffits thord oot then it will cook even and stay moist. Dunt fergettid to take the jiblits oot anorl.
Hippo
Lord Hippo
- Posts
- 53,839
They dunt give yer the eggsact location to stop the driver being chased. Or van stolen.eggspecting an amazon delivery today.. the van has gone past my house twice so far, now according to the app is over a mile away
dont they dont use a delivery route planner
- Posts
- 33,600
- Location
- North Shropshire
No they don't, but close enough i could see him scribbling over the map
Hippo
Lord Hippo
- Posts
- 53,839
Shud be cheaper to cook wivva air fryer, if comparing to a lectric or gas cookerer.Sounds good but as it takes the same amount of time as my method I can't see the advantage of using air fryer.
I roll it in paprika then put in frying pan with a little hot oil
High heat for 2 mins then turn it over, put lid on and simmer for ten mins
Then turn off and leave without touching it for a further ten mins
it will be nicely done and moist
Works for me
- Posts
- 33,600
- Location
- North Shropshire
Just talk rubbish for half an hour, can do that for free
Hippo
Lord Hippo
- Posts
- 53,839
Yer be surprised how many vans gettid nicked. Also peeps following vans to nick parcels left unattended at the delivery address.No they don't, but close enough i could see him scribbling over the map
- Posts
- 33,600
- Location
- North Shropshire
Yep there was a spate of that round here a while back
- Posts
- 9,000
- Location
- Solent
One good thing about havin a wuks addresses to deliver at
Gots to have a plus sometime
- Posts
- 33,600
- Location
- North Shropshire
Used to get away with that years ago, reckon I'd get a p45 nowOne good thing about havin a wuks addresses to deliver at
Gots to have a plus sometime
- Posts
- 9,095
- Location
- North Lincs
Working from home also has some benefits
- Posts
- 16,354
- Location
- Benfleet, Essex
Morning All.
Not bad out there this morning, no rain and 9° today.
Have a great day!
Not bad out there this morning, no rain and 9° today.
Have a great day!
Could be cheaper ??
My induction hob would only be on high for two mins and medium for 10 mins, total 12 mins
Air fryer on for twenty mins on high
Needs an experiment
JimS
Well-Known Member
- Posts
- 10,715
- Location
- Not far enough away from London
Could be cheaper ??
My induction hob would only be on high for two mins and medium for 10 mins, total 12 mins
Air fryer on for twenty mins on high
Needs an experiment
Ditching the gas hob for an induction in the kitchen refit, crazy I know with the leccy prices but I'm working on the assumption things get hotter quicker
Similar threads
