fett
Well-Known Member
- Posts
- 8,637
- Location
- South Hampshire
K seal!
got the heads off
- Thread starter not again
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
have your heads gone off to be done? have a look at your therm as well i keep you busy, but better doing it now than having to start again. best of luck j
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
fett, thats bad irontite is best lol
not again
New Member
- Posts
- 41
- Location
- birmingham
the gasket blew from the edge of cylinder to the edge of the block with no water loss or overheating so im guessing all will be ok
not again
New Member
- Posts
- 41
- Location
- birmingham
yes the heads have been sent away to be tested and skimmed
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
are you sure thedeck of the block looks like one piece of metal? if it does just re gasket it and put it all back together. you may have been lucky and got away with it!
not again
New Member
- Posts
- 41
- Location
- birmingham
put a straight edge across it and it all looks fine i am feeling like the luckiest p38 owner in the country at the minute
gavbriggs
Well-Known Member
- Posts
- 5,861
- Location
- Sheffield uk
be afraid, be very afraid!!!
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
i hope that lasts dont forget to give your rad a good flush while its all apart
fett
Well-Known Member
- Posts
- 8,637
- Location
- South Hampshire
