Regarding tow ball height, that's why I wrote check recommended height and adjust hitch to suit. Regarding axle loads I simply meant that with towball at correct height trailer will be horizontal, so all will be doing their share.
General towing question - car trailer nose weight
- Thread starter Daze
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Regarding tow ball height, that's why I wrote check recommended height and adjust hitch to suit. Regarding axle loads I simply meant that with towball at correct height trailer will be horizontal, so all will be doing their share.
pauldaf44
Active Member
- Posts
- 440
- Location
- Carmarthenshire
Good point actually, something that I haven't checked. Just popped out to have a look, quite tricky to get photos of, but this is from the engine-side between fan blades
And this is from the front looking up between grille slats
Looks decent to me? I'll bring a spare thermostat with me as part of my spares box
That rad does not look too bad at all. Mine had nearly no fins left. When I took it off the car the remaining fins mostly fell out. Where does your temp gauge sit. Mine before changing rad sat at 1/2 way up the gauge and a needles width above half if working. After rad and stat change it now sits steady 1/3rd of the way up the gauge and never fluctuates. Engine seems happier as well so I suspect my gauge undereads and she was running too hot before.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
In France, a trailer over 750Kg has it's own registration, log book and insurance. Soon I believe it will also need a MOT.
OP, the max hitch weight on a P38 is 150Kg I imagine the disco will be the same. I generally aim for 100 Kg. I have a jockey wheel with a built in balance. With a 3 axle trailer, there should be no question of the jockey wheel collapsing when unhitched if the weight distribution is correct.
Just load the car and move it forward slowly until there is a just noticable dip at the hitch, that will be near enough.
dirtydog1950
New Member
- Posts
- 9
- Location
- Swindon Wilts
Hi Daze another thing to consider is your GTW ( Gross Train Weight ).
In the car is a plate showing each axle loading with the GTW. If you are certain you are within these parameters OK. If not you will have to go to a weigh bridge to check.
As a sideline VDSA ex VOSA are having a field day in the west country with car/caravan combinations. Spot checks are scheduled for this summer so anyone coming this way beware.
Safe towing and have a good journey.
Derek
In the car is a plate showing each axle loading with the GTW. If you are certain you are within these parameters OK. If not you will have to go to a weigh bridge to check.
As a sideline VDSA ex VOSA are having a field day in the west country with car/caravan combinations. Spot checks are scheduled for this summer so anyone coming this way beware.
Safe towing and have a good journey.
Derek
- Posts
- 3,275
- Location
- Rushden, Northants, UK
We regularly tow heavy trailers with both our D2 V8's, and in the main they are pretty easy to set up and tow with as long as you follow the basics.
You'd be unlucky or stupid to exceed the noseweight of the Discovery, 150kg for the D1 and 250kg for the D2.
Tyre pressures and load in the boot affects things more than you would expect, if you are going to carry half a ton of tools etc, fold the rear seat down and get the weight well forward.
Our turntable drawbar trailer only imposes about 30kg towbar load, but the 4-wheeler is usually up around 80-100kg with the dynamometer engine loaded.
Braking shouldn't be too badly affected if your trailer brakes are in good shape, but I always try and leave a bit extra room where I can.
Peter
You'd be unlucky or stupid to exceed the noseweight of the Discovery, 150kg for the D1 and 250kg for the D2.
Tyre pressures and load in the boot affects things more than you would expect, if you are going to carry half a ton of tools etc, fold the rear seat down and get the weight well forward.
Our turntable drawbar trailer only imposes about 30kg towbar load, but the 4-wheeler is usually up around 80-100kg with the dynamometer engine loaded.
Braking shouldn't be too badly affected if your trailer brakes are in good shape, but I always try and leave a bit extra room where I can.
Peter
thebiglad
Well-Known Member
- Posts
- 7,387
- Location
- Central France
Hi Derek just for your info the GTW of a Disco I (the vehicle in question) is approx 6600kgs from memory.
So with the car itself plus average weight driver at 2230kgs + 600kgs of tools + 1900kgs for loaded trailer the OP will be well within the GTW.
Dave
dirtydog1950
New Member
- Posts
- 9
- Location
- Swindon Wilts
Dave,
More for info than specific vehicle. Obviously all road users, solo and towing, need to be aware that weight limits apply to cars as well as LGV's. I also appreciate that this topic has been well covered, in other threads, but a subject to be of interest to all road users.
Derek
SteNova
Well-Known Member
- Posts
- 2,200
- Location
- N. Wales, LL22
srtgray
New Member
- Posts
- 475
- Location
- On the Lake Geneva Shoreline
I thought that was the case already? When I lived in France a few years ago, my Sankey trailer just avoided needing one.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
Never had to have the caravan MOT'd, I know it's been talked about but not seen any directive on trailers up to 3.5 tonnes gross loaded weight for private use.
