P38A Emissions

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

oakey

Well-Known Member
Full Member
Posts
2,101
Location
Mull of Kintyre
1995 4.6 V8 210k
Only just failing emissions and suspect one cylinder is not firing properly. Not a full blown misfire, more like a not full fire on one cylinder.
Changed plugs leads and coil pack.
Suspect a burnt ish valve
Going to compression test then take heads off
Anything that I should do at same time?
 
They were a bit blackk but that was probably from being started just to move it
I had noticed the partial misfire a while ago when pulling hard.
Fails on hydrocarbons after the hi speed bit
 
Thanks for all your replies
Before MOT I intended an Italian Tune up but had a heart attack so that didnt happen
Lambda sensor was changed just before MOT cos Nanocom said it was
 
My compression tester which I hadnt used for years, didnt fit. Need to make an adapter of some kind. Will see what results are this week I hope if allowed out to play
Thank you for all your good wishes
 
Back
Top