P38A EAS issue 35mph max, normal ride light only.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse said:
That is defo fubar and a clear cause of an issue, we will wait the out come with new fuses:D
Click to expand...
Thanks Brian, new 10A fuse fitted, engine started with no 35mph warning, EAS cycles up and down as it should! While I was out I picked up Soldering iron (couldn’t find mine!) solder, shrink sleeve and heat gun. A job for when it a tad warmer!
Many thanks gents for all the tech direction. Till next time!
 
Richdove said:
Thanks Brian, new 10A fuse fitted, engine started with no 35mph warning, EAS cycles up and down as it should! While I was out I picked up Soldering iron (couldn’t find mine!) solder, shrink sleeve and heat gun. A job for when it a tad warmer!
Many thanks gents for all the tech direction. Till next time!
Click to expand...

Lesson learned: always check fuses and relays first!
 
Yep agreed but still would have had to clean connectors in footwell side panel I recon. Rx values were only seen after I did that. Though after I replaced the fuse the fault cleared so no need to have got the unlock cable and software on this occasion. Still it passed a few hours and I learnt a bit. Once again, thanks gents.
 
When you attack the footwell connectors, check for corrosion on the copper wires as well. On mine the corrosion had worked its way up the cable, and made them impossible to solder. Strip the wires & immerse into a cup of Bicarb & white vinegar for 20mins. Then washing thoroughly with contact cleaner makes the wires shiny again & ready to solder.

https://www.instructables.com/How-to-perfectly-clean-wires-in-minutes/

20140517_152845.jpg
 
Richdove said:
Yep agreed but still would have had to clean connectors in footwell side panel I recon. Rx values were only seen after I did that. Though after I replaced the fuse the fault cleared so no need to have got the unlock cable and software on this occasion. Still it passed a few hours and I learnt a bit. Once again, thanks gents.
Click to expand...

Definitely.

oakey said:
Bicarb and vinegar at same time??? or consecutively?
Click to expand...

Vinegar and table salt (the salt enhances the acidity) to start with and then bicarb afterwards to neutralise the acid.
 
You must log in or register to reply here.

Similar threads

feyniriel
P38 EAS problems
Replies
18
Views
1K
pwood999
pwood999
B
P38A P38A 1996 4.6 Auto HSE EAS slow to lower and rise + random height change to extended height + compressor running too frequently.
Replies
9
Views
1K
Datatek
Datatek
W
P38 EAS Down on One Corner
Replies
9
Views
2K
pwood999
pwood999
P38Joe
P38A P38 - intermittent EAS fault
2
Replies
35
Views
4K
cornishboater
cornishboater
S
Interior Light Issue
Replies
10
Views
1K
EricTuk
E
Back
Top