Disco 2 sls

marky320 · Mar 5, 2013

I have just bought the self levelling sensor for the back of my disco 2 but on reading the manual it seems i will need to re configure it using a test book is this correct as i dont have one so it might not be a diy job after all. thanks for looking
i am in sunny norwich

nathan5346 · Mar 5, 2013

No idea but it might be an idea to state where you are so if it does and someones near they may be able to help

Richbee · Mar 5, 2013

Not sure if you can do it with a Nanocom?

I can help if you're visiting the Nottingham/Newark area

Richbee · Mar 5, 2013

Or you could try this site, see if anyone is close by

www.discovery2.co.uk/ Nanocom Locator, get help from your Land Rover Buddies!!!

Ahaggar · Mar 6, 2013

Easy without testbook. Simply disconnect the battery and wait maybe 20 minutes then change the sensor and reconnect the battery.

The connector is a bit tricky to open and close, a bit easier if you unscrew the sensor first and then open the connector.

Is a 10 minute job.

HenryD · Mar 6, 2013

Ahaggar said:
Easy without testbook. Simply disconnect the battery and wait maybe 20 minutes then change the sensor and reconnect the battery.

The connector is a bit tricky to open and close, a bit easier if you unscrew the sensor first and then open the connector.

Is a 10 minute job.

Agreed,so long as battery is off it'll go back to its last settings.

marky320 · Mar 6, 2013

had a fiddle and it dropped onto the floor and no amount of pressing buttons worked so had to bite the bullet however never disconnected the battery but luckily for me it reset itself it would seem it has been riding slightly lower or maybe i just been staring at it for to long thanks for your input guys

jonny2tanx · Mar 6, 2013

Ahaggar said:
Easy without testbook. Simply disconnect the battery and wait maybe 20 minutes then change the sensor and reconnect the battery.

The connector is a bit tricky to open and close, a bit easier if you unscrew the sensor first and then open the connector.

Is a 10 minute job.

Erm, how can it be a 10 minute job if you have to wait 20 minutes?

Ahaggar · Mar 7, 2013

Sorry, my mistake ;-)

Spunka · Mar 7, 2013

jonny2tanx said:
Erm, how can it be a 10 minute job if you have to wait 20 minutes?

And tea breaks

Disco 2 sls

marky320

New Member

nathan5346

Well-Known Member

Richbee

New Member

Richbee

New Member

Ahaggar

Active Member

HenryD

Active Member

marky320

New Member

jonny2tanx

Active Member

Ahaggar

Active Member

Spunka

New Member

Similar threads