Diffs ???
- Thread starter mickdj
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mickdj
New Member
- Posts
- 314
this is what i wanted to know. Diffs ??? - Land Rovers Only - Land Rover Forum
- Posts
- 83,296
- Location
- Embasinga stocæ
next time - do a ****in :search:
- Posts
- 83,296
- Location
- Embasinga stocæ
better still - **** off and ask on there.
fenby1976
New Member
- Posts
- 1,036
- Location
- West Wales
I don't think it's a good idea to use higher ratio diffs if you have a standard engine esp. a diesel. It will make it a bit crap off road ie. not so much control when descending and the engine might not have enough power to climb very steep hills. If you have a LWB then Range Rover / Disco diffs won't fit the rear axle.
Davec
New Member
- Posts
- 2,131
I thought he got an answer in 2 minutes here.
- Posts
- 83,296
- Location
- Embasinga stocæ
he did - but it werent simple enuf.
Between DEfenders and Discos / RRs, the overall final drive ratio in HIGH RANGE is fixed by the Transfer box gear ratios.
Fitting Disco transfer gears to a Defender does what you say - poor man's overdrive..
Remember, doing this will up ALL the gears, including first and reverse, so starting off with a 3½ ton trailer won't be quite so easy.
Use low range to get it rolling then snick it into high range, and NEVER slip the clutch to get a big load moving.
Big truck trick is to use a very LOW gear from a standing start, let the engine idle, and on no more than idle speed ease up the clutch gently. The truck will move off, and you can let the clutch pedal right up. THEN you deck the GO pedal. Same in every gear, clutch pedal right up, THEN hit the gas. With 15 well-spaced gears it's a breeze.
LandRover clutches appreciate the same kindness.
CharlesY
Fitting Disco transfer gears to a Defender does what you say - poor man's overdrive..
Remember, doing this will up ALL the gears, including first and reverse, so starting off with a 3½ ton trailer won't be quite so easy.
Use low range to get it rolling then snick it into high range, and NEVER slip the clutch to get a big load moving.
Big truck trick is to use a very LOW gear from a standing start, let the engine idle, and on no more than idle speed ease up the clutch gently. The truck will move off, and you can let the clutch pedal right up. THEN you deck the GO pedal. Same in every gear, clutch pedal right up, THEN hit the gas. With 15 well-spaced gears it's a breeze.
LandRover clutches appreciate the same kindness.
CharlesY
