- Posts
- 58,170
- Location
- Preston Lancs.
Rad must be hot top and bottom both sides.
P38A Diesel Head gasket again
- Thread starter tarphenry
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Rad must be hot top and bottom both sides.
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
Further test ,at tickover ,with the cap off it doesn`t reach operating temp. just over 1st white line. rad is cold all along the bottom and water in header tank is cold
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
is it possible that the stat is not opening allowing the water to circulate. its a recent problem, done over 3000 miles since head replaced and this started last week. Fan seems good,cannot stop it when warm.
- Posts
- 58,170
- Location
- Preston Lancs.
Is the rad hot across the top and cold across the bottom after warm up?
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
yes hotter on passenger side than drivers side
- Posts
- 58,170
- Location
- Preston Lancs.
So it is generally hot across the top but cold across the bottom?
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
yes it is
- Posts
- 58,170
- Location
- Preston Lancs.
Looking from the front of the car, hot coolant enters the rad from the right hand hose, it should then go down the right hand side of the rad and up the left hand side back to the engine. If the rad is generally hot across the top but cool across the bottom either the rad has no baffle in it or the baffle has failed.
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
I see your point, I will remove the rad tomorrow and get another one thanks Wammers it makes sense. not likely to be the stat then ?
- Posts
- 58,170
- Location
- Preston Lancs.
If the baffle is not present coolant just flows across the top of the rad and never gets cooled. You can check for a baffle by dropping a marble in one side and tilting rad. Marble should not roll across to the other side. Baffle should stop it. Make sure new rad has a baffle there are some about that don't have one. If it has no baffle it's as useful as tits on a Mars bar. Nissens rads are good and have the baffle.
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
yes willdo tomorrow
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Once it’s off check stat isn’t stuck/renew same time.
I used cheap stat with small hole drilled back when we did head sensors, and I’m still fine.
I used cheap stat with small hole drilled back when we did head sensors, and I’m still fine.
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
mine has been fine all summer ,did 260 mile trip a couple of weeks ago ,then thurs last week " all hell breaks loose"
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
I understand, I had similar issues before I tackled my cooling system and followed your threads accordingly.
If you are concerned it’s head then you can get a dye that shows up combustion gasses in water cheap enough. Personally I don’t think it’s that, you had the head off last time
If you are concerned it’s head then you can get a dye that shows up combustion gasses in water cheap enough. Personally I don’t think it’s that, you had the head off last time
- Posts
- 58,170
- Location
- Preston Lancs.
Good luck.
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
thanks will let you know if I find anything
Henry_b
Think outside, no box required.
- Posts
- 15,506
- Location
- somewhere else
Tits on a Mars bar?!
Thats a new one!!!!
Thats a new one!!!!
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
New
New as Wammers yes.
New as Wammers yes.
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
You’ll like the one about UJ like a whippet Henry lar
- Posts
- 58,170
- Location
- Preston Lancs.
Tits on a Mars bar?!
Thats a new one!!!!
No i have been using it for a very long time, since possibly well before you were born.
