Hello everyone,
I'm sorry to post this as a separate topic, as i tried before in a less specific sense. I had some great help and advice, but haven't solved the final bit yet.
I am fitting a rear wash system (complete from scratch because it wasn't specified / fitted from factory). The rear door wiring loom has been purchased and trial fitted, along with wiper motor, arm, blade, pipe, jet etc etc. At the dash, the switch has been purchased and the connector for it was already there in the dash, plugged into a dummy switch. All good.
I have had a look at the reservoir bottle end and confirm there is no pump (now purchased) nor wiring loom / connector (that i can see) unless it's pretty well hidden.
My question is whether the wiring from the dash switch connector does make it's way through the bulkhead and is sat there on nearside / front somewhere? I am going to take off the dash top (maybe lower dash also) to have a look and see if I can trace the wiring. Just before I do that, has anyone done this before that can confirm whether the loom is there and or where it might be?
Thanks for looking.
I'm sorry to post this as a separate topic, as i tried before in a less specific sense. I had some great help and advice, but haven't solved the final bit yet.
I am fitting a rear wash system (complete from scratch because it wasn't specified / fitted from factory). The rear door wiring loom has been purchased and trial fitted, along with wiper motor, arm, blade, pipe, jet etc etc. At the dash, the switch has been purchased and the connector for it was already there in the dash, plugged into a dummy switch. All good.
I have had a look at the reservoir bottle end and confirm there is no pump (now purchased) nor wiring loom / connector (that i can see) unless it's pretty well hidden.
My question is whether the wiring from the dash switch connector does make it's way through the bulkhead and is sat there on nearside / front somewhere? I am going to take off the dash top (maybe lower dash also) to have a look and see if I can trace the wiring. Just before I do that, has anyone done this before that can confirm whether the loom is there and or where it might be?
Thanks for looking.