RangeRoller dt
Well-Sprung Member
- Posts
- 14,411
- Location
- Trapped inside my head @ LZ asylum
Like how it’s same mesh inside and out.
Nice shirt
Nice shirt
Like how it’s same mesh inside and out.
Nice shirt
@Doo
Looks like ur having too much fun there , lol
May i ask about the small sprayer , how have u found it please, any good ??
Many thks and keep up the good work buddy
I have one like that. Paint needs well thinning.
That's ok. My mate has a LAUNCH Android code reader that can do everything except the EAS (I have software on my laptop for that).
I had to keep the battery connected to lock/unlock the car because there are some nuggets out there who think they are more entitled to my stuff than I am, even though I paid for it
One thing that confused me was the low brake fluid warning No doubt due to the many disconnections
Anyhoo, here's what I used for the heater box foam. It expands to 15mm, but in reality it went a lot higher, had to push the dash down so defo sealed.
The wiring for the LED and the other sensor was a right pain to poke through the wee round hole. Had a mate helping so he got that task...Cable tie helped too
My mate took down some cleany stuff (he has his own valeting business) and cleaned one of the seats and a couple of door cards. I bought the interior used and boy was it bad used (stupid people taking dawgs and coffee in their cars )
State of this cloth after one pass on the drivers door card
He said we need to touch up the worn parts.... Just as well I got one of these babies then
Resting today, still got the radio to re-doo and mess around with the wiring. I've run extra wires to the back of the centre cubby to install USB in the rear ashtray for rear passengers to charge their phones and such.
It's all coming along nicely.
Bit worried about doing the radius arm bushes
I got the full front & rear set
I'm planning replacing the bolts too, but I hear LR want a lot of cash for each bolt...£9
Is there something special about the radius arm bolts? I can get bolts at the local bolt shop a lot cheaper, so what should I be getting??
Many thks, just thought it would be perfect to spray my door handles
Daft question plse, how do u know the paint is thin enough , do u have to use something like a viscosity cup and time it takes for the paint to go through
Thks as always
If it's too thick it won't spray simple, you just get used to mixing it. Spray very fine coats and build up. I use mine for model making.
Perfect , thks buddy
Will get one later , my uncle useto do a lot of model making , mainly tanks, soldiers etc and used a small airbrush
Hi chaps, sorry for the late response....Been up to me eyes with the rebuild
I haven't actually used it yet so can't comment, but my paint is water based so just a case of adding drops of water to the mix/
Tell you what, I'll give a report when I get around to it though
However, I am utterly devastated at the moment....
I'll share.
My neighbour is absolutely gorgeous and a fabulous neighbour, friend, mum, etc.
Her man on the other hand is a fucking cunt of the very worst sort
I wont go into detail other than she's been treated like shit for a long time. Told her to bin him, he went to jail for crimes against her and "still" she stuck with him Recently, she got in touch and I went to visit. She broke down and spilled a lot of beans. I listened and said she needs to get rid... When my wife came home from work I urged her to visit our friend and after around 2hrs, finally persuaded her to go to womens aid.
So, I was warned that because of my (our) part in it, the fucktard would likely damage my car So I parked wifes car hard up against mine so the tit couldn't get near. Job done. He appeared at 03:00 and couldn't get in, couldn't get near my car so left...
Next day I went to move wife's car to gain access to mine. I place the switch pack & stereo touchscreen on the windscreen of her car (it was the only place I had...) moved her car and all was well, until I went to get out and somehow looked (touched) the wiper switch...
Suffice to say, all these weeks of hard work down the pan pretty much as far as the radio is concerned. Smashed the edges and a couple of cracks on the screen itself so it's obvious.
Fucking French surrender monkey
Stupid asshole ex boyfriend threatening twat, all his fault
Actually, all "my" fault for being an idiot
Anyway, I can fix it, but what a friggin upset after all my effort.
However, the HEVAC is working beautifully, although the cold isn't so cold anymore, so time to refill the AC More expense
Next is the passenger seat heating element repair followed by the radius arm bushes, all of them front & rear....what fun
....but that smashed screen
House contents insurance?
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!