Rangieman123
Active Member
- Posts
- 112
- Location
- Dublin, Ireland
Seeing as you have the correct sender, I'd suggest checking if you have the right voltage stabiliser.
Classic temp guage clocks sender or head
- Thread starter Bern768
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Voltage stabiliser ?
Rangieman123
Active Member
- Posts
- 112
- Location
- Dublin, Ireland
The fuel and temp gauges will get their power feed via a small metal box about half the size of a box of matches. This stabiliser reduces the voltage to power the gauges and also helps to buffer and slow the movement of the gauge needles. If you have the wrong one fitted, both of your gauges can over or under read. The stabiliser is usually mounted somewhere behind the main instrument cluster.
The saga still continues, I have checked wiring had dash out checked the rubbish ribbon on the back of the dash and voltage stabiliser Seems to work as it should , I have replaced the temp sensor , thermostat and even the rad as that looked gunky , been for a drive and still goes over the 3/4s mark , stopped lifted the bonnet and the rad core is stone cold but both top and bottom hoses are hot , as soon as I stopped the engine within about 30 seconds the core begins to get hot , filled the system with the bleeds off so there is no air in the system , and doesn't blow any out under pressure, am I missing something stupid?
It was an alloy one off of eBay, just listed as 300tdi discovery, fitment was the same and has a baffle plate between the top and bottom so can't figure it out
Hicap phill
Well-Known Member
- Posts
- 16,242
- Location
- Wiltshire
Flush with a hose pipe to make sure there is water flow.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
If the baffle you are talking about is in the top header like the P38, check that it is actually there. The symptoms are just like a P38 diesel with the baffle missing or failed.
- Posts
- 12,628
- Location
- Sud ouest France !
Yer it's a brand new thermostat, and rad is brand new , and a brand new temp sensorIs the thermostat present?
I've not seen all the thread sorry.
I mean the baffle in the rad itself that separates top to bottom,You saw where I was going.
J
- Posts
- 12,628
- Location
- Sud ouest France !
So does your rad feed at the top from left to right or vice-versa?
Or top to bottom on 1 side?
I don't know the rad which was why I asked for a pic.
J
- Posts
- 12,628
- Location
- Sud ouest France !
Sorry marjon, I meant to point it towards our mate with the complaint. But you can show us pictures of all of yours
I know what you meant, but I don’t know which why the OP flows which was why I askedSorry marjon, I meant to point it towards our mate with the complaint. But you can show us pictures of all of yours
.I can never get mine all herded in 1 place for a pic
.J
It's top and bottom both on the same side , and oil cooler pipes on the other
Attachments
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
So it's a cross flow RAD? I which case there has to be a baffle in the header between the flow and return, if it's either not there or has folded over there will be problem.
I will look at that thank you
Similar threads
