tottot
Well-Known Member
- Posts
- 8,109
- Location
- west wales coast
Can you pump pedal to a higher point? And it hold there under your foot for a while.
Last edited:
Brakes issue
- Thread starter Singr07
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Singr07
Active Member
- Posts
- 113
- Location
- Birmingham
Hi I can yes, or lock it with a long piece of wood. How long do I have to hold it for?
Someone else mentioned that G-valve can cause this issue NRC8215?
tottot
Well-Known Member
- Posts
- 8,109
- Location
- west wales coast
30 seconds is enough, shows there is no leakage past master seals.
Issue you have then is either there is still air in the system.
Or the brake rod / master cylinder adjustment is incorrect. Just because it was right for the old master does not mean it is right for the new. Only 2/3 mm play needed.
@Harvester in another post here has the opposite issue I recon.
Issue you have then is either there is still air in the system.
Or the brake rod / master cylinder adjustment is incorrect. Just because it was right for the old master does not mean it is right for the new. Only 2/3 mm play needed.
@Harvester in another post here has the opposite issue I recon.
Singr07
Active Member
- Posts
- 113
- Location
- Birmingham
Thanks for your advice, I tried holding the brakes but no luck but another trick has worked as I tried to describe below
Last edited:
Singr07
Active Member
- Posts
- 113
- Location
- Birmingham
Hi I blanked off rear brake brake line from MC and straight away brake peddle becomes stronger not sinking anymore so the rear brakes G-Valve is faulty part number NRC8215.
Now the trouble is it’s not available any longer. What would be the alternative to this G-Valve please?
Now the trouble is it’s not available any longer. What would be the alternative to this G-Valve please?
