biggeeeee
Retired - Living the dream
- Posts
- 11,090
- Location
- Lanarkshire or Argyll
Please don't say that.,might be pension day,so he can go out for his monthly treat meal,big mac and a coke.
And sit with his stretchy pants on all day
brake pedal pulsing under braking
- Thread starter starr870
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
And sit with his stretchy pants on all day
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
And maybe his adult anti dribbling pantsAnd sit with his stretchy pants on all day
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
starr870
Member
- Posts
- 28
- Location
- Melksham, Wiltshire
Ok just a quick update, I changed the discs and pads today and although better I can still feel the pulsing through the pedal very frustrating!!!!
Andy.
Andy.
sierrafery
Well-Known Member
- Posts
- 17,870
- Location
- Arad/Romania
It can happen if one of the two pistons of a caliper is sticking ...did you check the calipers too?, if not there are quite cheap rebuild kits available, e.g http://www.island-4x4.co.uk/brake-caliper-seal-stc1919g-p-196.html
- Posts
- 83,279
- Location
- Embasinga stocæ
This might help........
Headtester
Active Member
- Posts
- 581
- Location
- Ruislip
Could be the Electronic Brake Distribution valve?
From Rave:
From Rave:
Operation of EBD is detectable from a stiffening of brake pedal movement as the inlet solenoid valves close and a
slight pulsing of the brake pedal as the inlet solenoid valves open. EBD operation ceases immediately the brake pedal
is released.
slight pulsing of the brake pedal as the inlet solenoid valves open. EBD operation ceases immediately the brake pedal
is released.
Had a very bad pulsing and just on hard braking a judder in the steering wheel when the wheel bearings were shot. But the problem was just there when you stepped on the breakers. When the pads managed to steer the wheel bearings in the right position the breaking was great.
jimalmighty
Member
- Posts
- 91
- Location
- Poole
I had a similar thing, thought it was the ABS module but I changed the wiring loom in the rear near side hub and it cured it. Cost £80 for the loom
jimalmighty
Member
- Posts
- 91
- Location
- Poole
Mine did throw up the three amigos tho
