Disco 2 Brake pedal going hard!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mad85

mad85

Active Member
Posts
503
Location
Malta
I had noticed the brakes are not so good and feel a little mushy. For instance an emergency brake does not feel so 'urgent'...

I also had an instance when going down a mountain quite fast and lost brakes at one point due to them overheating (with steam coming off the front calipers and some where under the intake manifold). Since then I got an overhaul kit for the calipers (they needed it), fitted ebc brake pads and fitted new bearmach drilled/slotted discs all round.

Yesterday however, after an hour of hard driving i also started to feel the brake pedal going hard and started loosing brakes. No steam this time but there was a smell and had very little brake assist.

Is there anything wrong with my brakes or is there anything i can do to improve this?

Thanks
Mark
 
Sounds like you have cooked your brakes again. If there is smoke coming off the pads then I'd say ther brakes are working well enough but you need to drive more carefully under extreme situationsto stop them getting so hot.
I have cooked brakes on a D1 once, going down this hill https://en.wikipedia.org/wiki/Porlock_Hill towing 2t. The pads will recover soon enough from normal driving but if the brake fluid is old and has boiled then the pedal will stay spongy until it is bled. New fluid would be a good idea
 
I think it would be ok, but no real benefit. I'd stick with 4 as it's easy to get and cheaper
 
Dot 5.1 is used with ABS systems but perfectly ok with earlier DOT4 systems as well,
But a complete fluid change is your first priority as brake fluid is hygroscopic and will absorb water over time,
With heavy braking that water will turn to steam and is compressible so your brake pedal will get very spongy,
I would also check if your servo is working well and your servo vacuum pipes are good especially the small feed one to your heater,
 
Check your rear brakes are working correctly. If they're not, your fronts will be doing far more work than they're designed for & will overheat.
If your fronts needed overhauling, I'm sure the rears will too as they usually deteriorate faster.
 
With the engine switched off apply the foot brake hard down then holding the foot brake hard down start your engine, if your servo is working you should feel the pedal go down slightly further as the servo assist kicks in.
 
Yes but if you have a vacuum leak from servo or hoses or duff vacuum pump then the first application of the brake
Will often work ok but subsequent applications will make the pedal hard and unresponsive , requiring much greater effort from you to stop,
 
Europa486 said:
Yes but if you have a vacuum leak from servo or hoses or duff vacuum pump then the first application of the brake
Will often work ok but subsequent applications will make the pedal hard and unresponsive , requiring much greater effort from you to stop,
Click to expand...

That makes sense, as that is quite similar to what i m experiencing. Any tips on finding the leak?
 
You must log in or register to reply here.

Similar threads

mad85
Disco 2 squeaking/grinding brakes when warm
Replies
5
Views
418
Andy Warren
Andy Warren
Z
P38A Random braking problem-sometimes extremely hard brake pedal
Replies
19
Views
1K
Datatek
Datatek
L
Disco 2 brake question
Replies
5
Views
628
landynutterme
L
F
V8 Idle & Brake Pedal issue - combined???
Replies
1
Views
235
discool
discool
P
Discovery 2 brake issues after replacment
Replies
4
Views
718
psk100
P
Back
Top