Disco 2 ACE Problem
- Thread starter Gros Niglik
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Gros Niglik
Member
- Posts
- 18
- Location
- Montreal
I had a failure would not operate the solenoids, swapped ECU and worked, due to amount being scrapped, tons of spares
sierrafery
Well-Known Member
- Posts
- 17,980
- Location
- Arad/Romania
Couldnt check on mine with nanocom cos my son took the D2 and went skiing for a week... changing the ECU to rule it out would be a god move... what about the warning lamp test ?
Gros Niglik
Member
- Posts
- 18
- Location
- Montreal
If the ECU is bad, I wonder what made it fail since it worked before I replaced the hydraulic pipes. Perhaps when I stupidly reversed the bottom two pipes on the valve block?
Gros Niglik
Member
- Posts
- 18
- Location
- Montreal
The warning lamp test did nothing.
sierrafery
Well-Known Member
- Posts
- 17,980
- Location
- Arad/Romania
Then the ECU must be ruled out before anythig else, they are not the best engineering and not very uncommon failure most of them due to moisture or water ingress in the area
Gros Niglik
Member
- Posts
- 18
- Location
- Montreal
I will order today
sierrafery
Well-Known Member
- Posts
- 17,980
- Location
- Arad/Romania
I dont think that the hydraulic side woud affect the ECU but as the output tests are all failing it must be ruled out before going further, then if no change it can become a bit complicated to diagnose so let's see what happens with a 100% good ECU first... make sure that F15 in the engine bay fusebox is good
Last edited:
Gros Niglik
Member
- Posts
- 18
- Location
- Montreal
What you say makes sense. ECU has been ordered. I also ordered another valve block just in case. From the photos it appears to be in excellent shape and it is guarajnteed. I think I wasted my money on the valve block but good to have a second spare.
Similar threads
Disco 2
ACE Fault
