300 Tdi no fuel at injectors

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Thanks all for the replies :D

To clear it up... she's a manual with a non-EDC pump.

I took out the plunger from the stop solenoid as suggested... sure enough I got fuel at the injectors and after a few cranks she fired right up... yippee! :)

Whilst I had the solenoid out I tested it, and it does seem to operate fine, which is odd. Tried putting it back in with the plunger but I got no fuel once again. Very odd!

Any suggestions as to the cause?
 
Just a quick thought; there wouldn't be any form of immoblisation on a late Defender 300 would there? (Engine code 23L).

There's a multiplug coming from the top of the pump with 3 pins in it, but I'm fairly sure this is EGR related and is redundant.
 
Langers said:
Just a quick thought; there wouldn't be any form of immoblisation on a late Defender 300 would there? (Engine code 23L).

There's a multiplug coming from the top of the pump with 3 pins in it, but I'm fairly sure this is EGR related and is redundant.
Click to expand...

yes 300's have engine immobiliser 3 wires sounds like EDC
 
not at pump unless its edc or has cover over solenoid ,wires at the throttle spindle are for throttle pot for egr can be left unplugged,presumed you have 12v at solenoid as car could have cutting feed at spider
 
jamesmartin said:
not at pump unless its edc or has cover over solenoid ,wires at the throttle spindle are for throttle pot for egr can be left unplugged,presumed you have 12v at solenoid as car could have cutting feed at spider
Click to expand...

It's definitely non EDC. I do have 12v at the solenoid, which has just a single male spade terminal.

Just curious as to why it wasn't letting fuel through even though it seems to operate as it should.

Ah well, I'll find out tomorrow when I fit the new solenoid
 
the 3 wired for the EGR are on the other end of the pump, attached to the throttle position sensor, not required for running.

it possible the solenoid will work under no load (ie off the pump) but doesn't have enough power to operate whatever it is it operates on the vehicle.
 
timtheenchanteruk said:
the 3 wired for the EGR are on the other end of the pump, attached to the throttle position sensor, not required for running.

it possible the solenoid will work under no load (ie off the pump) but doesn't have enough power to operate whatever it is it operates on the vehicle.
Click to expand...

True :)

New solenoid ordered from John Richards last night. I'll just stall it when I want it to stop until it arrives... still got PLENTY to do before I can MOT it anyway.
 
You must log in or register to reply here.

Similar threads

W
Bleeding fuel system after pump repair
Replies
5
Views
767
lynall
L
M
200 TDI fuel problems
2 3
Replies
59
Views
4K
Anaconda
A
D
Discovery 1 300 tdi auto Fuel issue
Replies
7
Views
662
discool
discool
stumpyj
Fuel Line worn through
Replies
2
Views
578
stumpyj
stumpyj
Randometer
300 TD Engine - Fuel Injection Leak - Help.
Replies
10
Views
1K
Randometer
Randometer
Back
Top