2006 RRS 2.7 tdv6 gearbox help please

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
So the plot thickens, I have looked at my 2005-2012 RRS DTCs.
I cant find a U0102 .

But all I can say is, if the car drove then broke down and was taken to a garage where some work was done I would investigate electrical connections as a first port of call.

And of course we all wait for Phil to come back with the answer :).

J
 

Attachments

  • RRS 2005-2012 transferbox DTC.pdf
    317.1 KB · Views: 118
  • RRS 2005-2012 gearbox DTC.pdf
    526.7 KB · Views: 127
Definitely thickens lol

It’s such a strange fault especially the fact it shows it’s going into RND etc and the cable moves and you can hear it move in the gearbox yet the car doesn’t
 
Definitely thickens lol

It’s such a strange fault especially the fact it shows it’s going into RND etc and the cable moves and you can hear it move in the gearbox yet the car doesn’t
Who/what gave you the codes?
As I said it may shift but as it doesn't know all is well it says "nope"

If you put the gearbox in neutral with the handbrake off can you move it?

J
 
Who/what gave you the codes?
As I said it may shift but as it doesn't know all is well it says "nope"

If you put the gearbox in neutral with the handbrake off can you move it?

J
I have an Autel mk808 and an icarsoft diag

Yeah gearbox in neutral and handbrake off I can push the car and it moves with no issues
 
Is there any oil in the gearbox?
Hi mark , there is , but I’m now thinking maybe too much. I had the car raised at the side so the fill plug was higher and when I started to undo the plug it started ****ing out. Would too much oil in gearbox cause the lack of movement when I gear?
 
Hi mark , there is , but I’m now thinking maybe too much. I had the car raised at the side so the fill plug was higher and when I started to undo the plug it started ****ing out. Would too much oil in gearbox cause the lack of movement when I gear?
There is a correct filling procedure which includes final filling at the right temperature. With the engine not running, oil will pour out. I doubt it's overfilled and I doubt that even if it is it would stop the car moving, might cause problems in use though.
Gear selection is done electronically, so corroded connectors are a possibility.
 
There is a correct filling procedure which includes final filling at the right temperature. With the engine not running, oil will pour out. I doubt it's overfilled and I doubt that even if it is it would stop the car moving, might cause problems in use though.
Gear selection is done electronically, so corroded connectors are a possibility.
I will check connectors again just incase. Would it just be the multiplug that goes into the gearbox?
 
There maybe(probably) 1 to the transfer box too.
As the fault seems to show coms between the 2.

J
I think there is 2 to the rear of the gearbox. I’ll be back at it tomorrow. I’ve noticed there is a comms fault with the parking assist module so I will locate that tomorrow and see just incase that’s throwing everything off
 
I think there is 2 to the rear of the gearbox. I’ll be back at it tomorrow. I’ve noticed there is a comms fault with the parking assist module so I will locate that tomorrow and see just incase that’s throwing everything off
Thars a good call as a lot of systems are linked and a code from one module can come from somewhere else sometimes 🤔
 
Back
Top